We are looking for the help with this washer . At the beginning of the cycle it starts filling with water ,
but it fills just a little and unit stays in the fill cycle . The tub rotates with the washplate together and
just stays in the fill cycle without adding a water.
- Harley Clark asked 9 years ago
Do you get an error code? Have you put it into diagnostics? Tech sheet should be on the front/left inside wall.
Drain pump may be clogged. Diagnostics would be a good start. It is likely a failure of the machine control, since it is supposed to be sensing the load size and determining the proper fill at the beginning of each cycle. It does not look like it is able to recognize the motor RPM’s, so if the RPS sensor is OK according to the tech sheet, then the control is bad.I would try looking for a video at ApplianceVideo.com. Here is the link https://www.appliancevideo.com/
Just type in your symptom and look for a free video.
- AV Repair Help answered 9 years ago
- You must login to reply
Please login first to submit.
