f3 e2 error when you use the micro I replaced the erc because there was no display now I get this code and I already checked sensor I was thinking about installing another erc
- Guest asked 9 years ago
we returned and replaced the control with a new one and checked for bad connections , also checked the schematic and this micro has no temperature sensor. results were the same .Oven works fine but micro giving same F3 E2 error . any other ideas?
- Guest answered 9 years ago
- You must login to reply
where is the sensor for the mcro and do you have part number for sensor
- Guest answered 9 years ago
-
we are not sure which sensor you are speaking of. could you please give location of sensor or part number?
- You must login to reply
Here is the info from the tech sheet for your F3 E2 error code.
- Disconnect power or unplug oven.
- Check microwave sensor connection.
- Measure sensor resistance: 280k Ω at 70° F (21° C), 1k Ω at 392° F (200° C). If resistance
is not valid replace sensor. - If sensor resistance and connections are good, then check for welded-closed relays on
the control. If relay shorted, replace control.
Make sure your the microwaves temp. sensor is testing at the correct ohm value. Also, make sure your connections for the sensor are good and check for damaged wiring or shorted components to ground. If everything tests good I would replace the electronic control. Attached is a link to the part.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
