Need error codes and diagnostics for LG DRYER

See repair video links that will help … https://www.appliancevideo.com/appliances/lg-dle1001w-dryer/
Hope this helps ,
Error Code
• Temperature sensor failure • Turn off the dryer and call for
service.
tE
• Humidity Sensor failure. • Turn off the dryer and call for
service.
HS
• House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
• Check the power supply or the
connection of power cord to the
terminal block. Refer to the Connecting
Electric Dryers section of this manual
for complete instructions.
PS , PF or nP
Possible Causes Solutions
Installation test (Exhaust check) (cont.)
• Electric dryer power cord is not
connected correctly, or house power
supply is incorrect.
Check the Error Code before you call for service
• Reset circuit breaker or replace fuse.
Do not increase the fuse capacity.
If the problem is a circuit overload,
have it corrected by a qualified

ACTIVATING THE DIAGNOSTIC TEST MODE
1. UNIT must be in standby (unit plugged in, display off)
2. Press POWER while pressing MORE TIME and LESS TIME simultaneously.
3. Press START/PAUSE button to advance through diagnostics.
To check pump operation:
At the fourth press of the test mode, if the AD value of the pump is higher than 10 on the display, the pump is normal.
If it is lower than 10, E5 error will be displayed.
1.This TEST should be used for Factory test /Service test. Do not use this DIAGNOSTIC TEST other than specified.
2.Activating the Heater manually with the Door open may trip the Thermostat attached to the Heater, therefore do not
activate it manually. (Do not press the door switch to operate the heater while the door is open )
Pressing the
START/PAUSE
None
Standard
Thermistor open
Thermistor shorted
tE
Power off
OO
Motor runs
Displays Moisture Sensor Operation
If moisture sensor is contacted with
damp cloth. The display number is
below180 in normal condition
255 = Low
moisture
30 = High
moisture
1HE(Elec. Type)
1H9(Gas Type)
d-
UDISPLAY
PGM
MAIN PGM
Current Temp.
(5~70)
Current Temp.
(5~70)
Electric control
&
Temperature sensor
ELECTRIC TYPE
Motor+Heater1(2700W)
GAS TYPE
Motor
ELECTRIC TYPE
Motor+Heater1+Heater2
(5400W)
GAS TYPE
Motor+Gas valve
Once Motor+Controller
Motor, Heater off
Loads off, Controller off
Twice
3 times
4 times
5 times
CHECKING
ACTION DISPLAY CHECKPOINT
ELECTRIC TYPE Heater 1 is
energized – 2700 W
GAS TYPE is not opened
(Temperature in the drum is
displayed in degrees C.)
ELECTRIC TYPE: Heater 1 and
heater 2 are energized – 5400 W
GAS TYPE: Gas valve is energized
(Temperature in the drum is
displayed in degrees C.)