not cooling

Hi. That is strange that the compressor and condenser fan motor still are not working after you replaced those parts. I can not think of anything else on this unit that would control power to these components. Did you program the new board correctly after replacing it? Go through the programing mode again to be sure the correct code is entered. I have attached the tech sheet for you. Go into diagnostic mode and run test 102 for the compressor and condenser fan. See if they come on. If not check for power to theses components. You can also check from the control board. The wiring diagram on the tech sheet will show you where. You may have a loose connection or made wiring. does the evap fan motor run?