My dryer powers on/off via power button just fine. The knob selector also works appropriately. The start button does not always register being touched. Likewise, other “buttons” do not sense being touched (Temp, dry level, dry time, options, set, cancel). When the dryer does start, there is a lot of rapid beeping during the drying cycle. I cannot enter into diagnostic mode or perform a factory reset due to the lack of response to the key pad. I attempted to replace the UI board (part # 5304505611) but that did not resolve the problem. Last night, after managing to get the dryer started and run through a complete drying cycle, the unit restarted on a cycle without the unit being touched.
replace the UI board (part # 5304505611)
- Guest asked 5 years ago
Hello, I have attached the tech data sheet with all testing procedures and wiring diagram . Based on the information you provided it sounds as if you want to look at replacing part number 5304508432. This is listed as “knob assembly with board” and/or “Washer User Interface Assembly” and communicates with the part you replaced . As you will see, the ribbon on the control that was replaced does plug directly into the part I am describing .
- Sam, Ace Appliance answered 5 years ago
- last edited 5 years ago
-
Replacing the knob assembly did not solve my problem. To date I have replaced the knob assembly as well as the UI panel. Could it be possible that the board (under the top panel, on the right side of the drum, housed in the black plastic box) is bad? What is that part called? Does it control the buttons on the front of the machine? Thanks.
-
Hello, the part you are speaking of is the main control board for the machine. Yes this also could be a cause of your issue. All power to the controls run through this . The part number is 5304509006.
- You must login to reply
Please login first to submit.
