Icemaker is not producing ice

Hello
Go to the the technicin diagnostics link below. Go to #25 on test procedure to cycle the ice maker.

1. Disconnect the power supply.
2. Slide the ice maker out, remove cover.
3. Jump “T” & “H” to bypass the Bimetal and start a harvest.
4. Tape both light switches closed
5. Connect the power supply, ice maker should start in about 5 seconds.
6. Observe the ice maker.
   If “T” to “H” is properly jumpered and the ice maker won’t run stop the test
   and check the ice maker.
7. Remove the jumper before the finger reaches 10:00 position . Reinstall the ice maker
   If optics wiring is disconnected with unit powered, plug harness , unplug the product for 30 seconds to reset Optics condition on Control board.
8. Immediately disconnect power after the water fill.
9. With the freezer door closed, reconnect the power supply.
   Matt Ace technician