The machine is level and secure on the floor. When I ran the spin test it would go up to 700rpm then stop and return to 0.
I checked the hall sensor and got the 3.8vdc but the motor windings on 1 was 11.6 ohm’s but the other 2 windings continually fluctuated from 6 to 20 ohms .
Does that indicate the windings are bad?
Will this cause the vibration?
Could it be the hall sensor? Is there another way to check it?

Model Number
Request Resource Materials
Service diagnostics guide, Service bulletins, Service pointers, Job aids, Videos, Any available materials

You may have a cracked spider in the drum. Bent drums are very common on Samsung. See Fast Track diagnostics manual link below.

Showing 1 result
Your Answer

Please first to submit.