Sir, my front load washer water , I start the cycle door locked with red light ,then water filled a splash stop. Door unlocked and locked again with no water filling and the door light on again After that wait 1 minute with error code f28. Please.advice thank

Model Number
Serial Number
What have you tried so far?

I tried a few time to restart cycle and nothing change . Also I to check the water inlet remove and check with continuity shoe resistance reading 0.8 like that

Request Resource Materials

Hello, the model # you provided is not valid. I do believe the model # we are working on should be WTW9400SW01. The F 28 error indicates that the communication between the Central Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly. There are certain tests that you need to perform to diagnose properly. I have attached the technical service sheet for this model which will give you the testing procedure(s) to follow for your resolution. Any information needed will be found on this technical service sheet.

Showing 1 result
Your Answer

Please first to submit.