All Answers

Hello
Go to the service manual link below. Then go to page #32 diagnostics and test #14 spin test. It will then give you the fault codes to determine you issue.

Hello
See links below for technical literature we have on this product.

check water pressure to both hot and cold hoses. If proper pressure will need to enter diagnostics and manually check both hot and cold pressure to unit. If no pressure between either hot or cold will need to check valve for proper voltage. If getting proper voltage will need to replace valve, if not getting proper voltage will need to replace control.

Hello, we do not have the exact video. We do have all of the disassembly manuals. See links below.

Hello
See sheets below. The model number is 3RATW3005TQ0.

Hello
We cannot seem to find this model number SM8525660 in our records. Could you please look at the model number tag on your washer to verify that it is correct. Thank you

Hello
See manual links below….

Hello
See out of balance Service Bulletin and all manual links.

Hello
Here are the technician and diagnostic manuals. There are no service bulletins for a no spin issue. Our senior technician will add more to this post shortly. Thanks

Unfortunately we do not sell any parts at all but if you go to Sears parts direct.com they have schematics and parts breakdowns on their website for your model number. They also have drop shipping direct to consumer. It’s your best route to go for parts.

Hello
See the service manual link Below. The drain pump diagnostics are on page #18 and #19 in the service manual link. Your second question is on the dv448gp/xaa. We normally start with the drum roller kit. The drum rollers are sealed bearings and are very common to make noise when they wear out. I would start there if its making noise.

Hello
See the service manual link below. If you have water and are not dispensing ice, you may have a defective auger motor. The auger motor is what turns the shaft in you ice bin to push the ice out. See page #46 in the service manual section 4.6 for auger motor details.

Hello
Go to page #47 in the service manual link below for all lid lock troubleshooting & diagnostics.

Hello
See manual links below along with service pointers.

Hello
See the service, diagnostic and wiring manual links below.

Hello
I have provided the service manual with your wiring diagram in section 5-57. I also provided a parts breakdown to be sure you have the correct parts.

Hello
Go to the service manual link below to page #33.
For gas models the two black wires go to (T) and (N) .
For Electric models its (T) and (M) .

Hi. If you installed the relay combo, p# WR07X10131 and the compressor is still not starting then your compressor is faulty and would need to be replaced. As long as your getting proper voltage to the compressor that is. Compressor replacement takes special tools and skills and is usually performed by a certified technician.

Hello
See links provided below for the service manual diagnostics. If your refrigerator is at 51 degrees, I would start with diagnostics on page #86 in the service manual link.