Brand: Electrolux

This fridge is completely dead, have 120 at source and 120 at board. Were do I start to figure out what is taking board out.

I put my temperature probe into the fridge, it read 53*. The freezer was 19*. Opened the back to check the compressor. It ran hotter than normal to the touch. Everything was working. This is the first time that I worked on an Electrolux appliance.
Could it be the inverter?

I looked at above refrigerator dispenser does not dispense ice or water sporadically. I plan to replace the dispenser module (part with the lever), not the user interface pcb. Has anyone else had a problem with that part? Thanks in advance

Customer says that they can only turn on one out of four burners. one comes on and when they attempt to activate other burners, they get intermitent flashing LED lights on readout. There are two LED readouts. one on left and one on right. after they activate the one burner and start to activate the others, the error code appears. left LED displays
” E ” and right LED displays ” 32 “. Sounds like control board but not sure.

The washer only leaks when in the spin cycle. When washer goes into spin it will start leaking from the center where the transmission goes thru the tub and it makes a grinding noise. If I replace the spin bearing will it also stop the water from leaking. Thanks Ricky

I’ve tested the air flow with a meter it is poor I’ve tested the igniter everything else inside is working fine there was a tremendous amount of lymph build up inside the machine cleaned everything out and still getting poor airflow reading

Has error code on display , do you have service sheet ? Thanks

my ice maker has quit making ice and the ice in the bin has melted. I suspect it might be a thermistor but not sure. If the thermistor was bad would it explain the change in temp in the ice maker compartment? All other areas are working fine. is there a diagnostic I can run on the unit? Code? to verify if the thermistor in ice maker is working correctly? Also, i show there are 2 different thermistors in the part diagram , can you tell me the difference. Thanks for your help.

Customer said the ice maker was making noise and no ice was being made. Tech did not hear any noise. Any suggestions as to where to start looking for problems in ice maker, being that there is no ice maker assembly and it’s all in individual parts?

THE BLOWER WHEEL KEPT GETTING STUCK SO I CHANGED IT.
BUT NOW I STILL HAVE THE SAME PROBLEM.
THE WHEEL WILL NOT MOVE FREELY. IT KEEPS TOUCHING THE SIDE OF THE HOUSING

the unit will sometimes turn sometimes not.
I got it to start working but then it will not stop.
I pressed cancel the display turned off but the unit will run .
I opened the door it stopped turning I closed it and it would start turning again

so I have changed the electronic control board.
and I am still having the E51 error

My Electrolux washer is not cleaning clothes properly.

My Electrolux washer will not start.

Hello I have a question on a Electrolux Refrigerator. I’m noticing these issues: Water dripping from dispenser

My Electrolux washer is leaking water.

I was getting the E51 error on the machine. it would not turn.
I ordered a new board the board I got is # 809160304.
however it is not the exact same set up for the wires o have a black and yellow in the old one each had a spot now I have 2 spots for 3 wires each.
and when I turn the machine on without the yellow and black it runs for a bit and I hear the heating element clicking and the I get the f 64 error.
can you please help me with 2 wires.

My Elextrolux washer stops in the middle of the cycle

My Electrolux refrigerator is not cooling properly.

My washer will not spin. Any suggestions?

My electrolux refrigerator is not making ice.

Having an issue with my washer.

My Electrolux refrigerator is not making ice.

only the timed dry cycle works.
all the others it will start and then stop

My Electrolux refrigerator is not cooling properly.

The door on my Electrolux washer will not close

My Electrolux refrigerator will not cool properly.