Brand: Jenn-Air

only the time is displayed on the control board none of the buttons work

only three of the burners will ignite.
the other one I see the spark but it’s very low and all the other burners click wehn I try to ignite it

Error code F6 E0 what does it mean and can I have a tech sheet for this unit thanks.

Are you able to get me the part number to the entire cartridge, including burners and all, where all I have to do is swap them out and not rebuild the entire thing?

My Jenn-Air dishwasher is not draining properly

My dishwasher will not drain the water out of it.

Jenn-Air Oven that is not working

Hello I have a question on a Jenn-Air Oven. I’m noticing these issues: Oven roller rack could fall off

When preheating the unit shuts off at 180f the panel and the entire unit shuts off. All elements and fuses are ok. The main board in the bottom of the unit was replaced.

Hello Gentelmen, would like to obtain the service information on this Jenn Air Gas range.
The oven will start to heat at first then shuts down. I noticed the display blanks and clears off .
If you have a service manual, wiring diagram, schematic, service bulletins. Have not made any checks yet.
Any service advise would be appreciated. Thank you.

Hello Matt and other sr techs.
I requested service information on this Jenn Air range. I felt that the electronic control board was bad. I replaced the control board . I have the almost same symptom . However both boards react in the same manner, when I try to put them in the service mode both will freeze up and some times freeze up before you get into the service mode. Neither bake nor broil will work. Both glow bars come on bake pulling 3.14 amps(with new board) 2.85(with original board) broil pulls 3.49( with new board) 3.25(original board) . With either board you can start into the menu and it will just lock up and I have to reset the breaker to start over. My thoughts are both original and new board are bad. Please advise , any thing you think I might have over looked. According to the manual it takes between 3.20 and 3.60 to open the gas valve. The current only stays over 3 amps on both bake and broil for about 2 to 3 seconds and rapidly drops off.

ice maker w10377151 has been converted to icemaker W10882923 unclear instructions on how to convert

I need to remove the icemaker. do you have a video>

Hi. My name is Joe. I am trying to trouble shoot a problem with my above mentioned refrigerator. I touched the water dispenser button to switch it from ice and the blue leds went black. I then tried all the other buttons and no matter what buttons I depress the small display lights up with blue diagonal lines across it. I believe at that time the refrigerator was still operating because I left it for 24 hrs before I started to try to diagnose the issue the first thing I did was to power down the unit for a few minutes the powered it back up. When that didn’t work I left the unit again for about 12 hrs and then we noticed that it was no longer cooling or freezing. I checked the interface board for power and I have 12vdc on two different sets of wires. I just want to confirmation that this interface board is my issue because it’s not returnable

door seems to be held on by 2 clips which are attached by some sort of rubber cement. is there a part # for this, or an after market product?

We are trying to change the Display/ Control Panel to replace it with a new part but we have ran into a wall per say. we can’t manage to get too the panel.

This code says cooling fan speed too low or won’t come on. Do you have a video on this one and a service manual and any tips?

I would like to know how to remove the mounting screw on the bottom of the unit. Do we have to remove the front door out? Would you let us know? The bottom screws are blocked with front door hinge , and not able to access the screw to be out. Thank you.

Customer said one time no burners would come on when set. Now the right front won’t boil water. Could this be a bad appliance manager board? Both duel elements work. Even on number 10 setting it will go off with a pan of water on it. Any advice welcome.

I suppose it is one of the two boards. I need a service manual.

the water valve is in the fresh food compartment. how to replace it.

The unit will start to heat and then I get the error code f8e0 underspeed fan.
I do hear and feel the fan blowing.
Please advise

My Jenn Air dishwasher JDB1270AWY has started making a grinding noise during part of the cycle. It is cleaning great and seems to be draining fine. Ideas?

Oven light turns on by itself , how can I prevent this from happening?

What Makes My Oven Smell So Bad When It Is Cleaning Itself?

Why Does My Gas Oven Glow Like It Is Hot Even When It Is Not Heating?