Brand: Kenmore

My Kenmore dryer is not heating where do I start ?

My Kenmore washer will not start.

what dose it mean and how can we fix it

no stove top action, oven works great,,,,, whats a poor boy to do ???? seriously,,, where can I look up codes?

I HAVE TWO, OF THESE UNITS, WITH SEALED SYSTEM PROBLEMS. PREVIOUS TECHS CUT NUMEROUS REFRIGERATION LINES. I NEED INFO ON PUTTING UNITS INTO DIAGNOSTIC MODE, SPECIFICALLY IN PREPARATION TO FINDING LEAK OR LEAKS AND RECHARGING. I NEED TO GET THE REVERSING VALVE IN THE CORRECT POSITION, ETC

i checked the pump for blockage
(none), for twisted hoses(none), for if motor is spinning the pump(it does) . i don’t know what else to do?

Researching this and wondering if service bulletin out there for this issue. Customer states doesn’t matter what size load. All I found is impeller issue but would like confirmation. Thank you, Steve

This kenmore elite is leaking water behind the icemaker. Coming out of upper part

can you tell me what this error code of erdh is?

The fridge was freezing food and also having cooling issues. Both cold controls were replaced and now the damper wouldn’t open. Replaced the damper and it still won’t open. Any ideas?

The heating element has burned out 4 times. The last 2 times they burned out faster than previously. Each time the element was replaced.

I need a wiring diagram. I traced the voltage loss to the relay but can’t tell if the coil voltage is right.

Our 3 yr old upright frost free kenmore freezer (2845) seemed to be cooling erratically and I noticed ice build up on the freezer bottom floor. I cleaned the ice off the floor and checked for leaking food – none. The ice has returned. I looked at your videos and think the problem may be a clogged drain. However, I’m not sure how to get at the drain on this model. Thanks for the advice!

F11 fault code no tech sheet in washer any help appreciated

My Kenmore oven is getting too hot.

Not heating, blinking complete cycle not staying solid

This washer isn’t completing the final high speed spin, it seems to skip it altogether. Clothes are still coming out sopping wet. Unit drains and cycles through all the other spots but this. Initially thought maybe it was the control but it checked out, also confirmed the drain and pump were clear, as well as the bearings being ok. Customer said sometimes it pauses, and she comes in and cancels/opens the door, closes it again, and hits start and sometimes it runs right from there and spins it out for her. Any guesses? Stumping me a bit.

We are having an issue with a Kenmore SXS refrigerator MN: 253.54629406 that keeps defrosting up. At first when we came out there we found it frosted up. The heaters and bi metal were working so we replaced the ADC board and forced into to defrost and heaters came on. Customer called back one week later and said same problem. We went back out there and thought the board we replaced the new ADC board, because we could not force it into defrost plus cold control, wiring assembly and dampener control and bi metal.Customer called back and is saying refrigerator works fine for a week then freezers up(same issue) Any help would be appreciated. Thank you.

This is a Kenmore Coldspot. The ice maker was replaced 4 months ago. Now the water is freezing up in he chute going to the ice maker.

Freezer section does not get down to 0F as it should. Mainly stays around 20F. Fresh food compartment sometime freezes item in the back on top shelf, otherwise section is cold enough. Does seem to run a lot but does shut off for long periods. Compressor is pretty warm but not “hot” to the touch. Lower fan at base is working, upper fan is working, pumping cool air into both sections. I have cleaned the cooling veins twice and would say there are a clean at I can get them.