0 votes
371 views

I need to replace defective PCB board

  • Loinest76 asked 8 months ago
  • last active 8 months ago
0 votes
417 views

I need to replace display control assembly some keys on the keypad are not working need service manuel

  • Loinest76 asked 1 year ago
  • last active 1 year ago
0 votes
398 views

This model is clamped down and screws in back of panel , which I removed. But I can’t get it off . I don’t want to crack the panel. This is a LG washer

0 votes
501 views

It is a combination wall oven /Microwave not heating.
Also if you can provide service manual.

  • Mgillani asked 1 year ago
  • last active 1 year ago
0 votes
444 views

On my refrigerator the freezer is cold but the refrigerator is not cooling. Started about a week ago when the freezer was freezing over And the refrigerator and we heard a loud noise like. We were told we needed to unplug the fridge for a few days because the fan was hitting blocks of ice. So we did and now the noise is going but the fridge section will not cool down the freezer section is very cold. Do you have any idea what this could be?

  • Rickeyj12 asked 2 years ago
  • last active 2 years ago
0 votes
864 views

Would like to know how to open the dryer to replace the rollers.

  • haivanpham asked 2 years ago
  • last active 2 years ago
0 votes
954 views
  • LG refrigerator compressor was not running and had a ticking sound coming from the inverter. All lights and all fans were running. Replaced inverter and compressor started immediately. Shortly after compressor turned off again, all lights and fans are running. Not cooling
  • Raideldz asked 2 years ago
  • last active 2 years ago
0 votes
899 views

I have Trouleshooted this unit, By; Running a Diagnosis-TEST on the Control board!!! 1.,2.,3., & 4. push on the test button, ALL the TESTS check out!!! There is NO-Check light flashing at ALL!!! BUT, this is the NEW type of Commpressor on this LG unit {Linear / Inverter Compressor}… I DO-NOT Know what Voltage should be going to this unit!!! The Compressor’s; sticker said: INVERTER 0–220V 53Hz… SO, when I check it with a DVM, I get a reading of; 35 Volts!!! The Compressor is Running, With “ALL” the Fans too!!! BUT, NOT–COOLING??????????????

What do you Think?????????

0 votes
929 views

The icemaker tray won’t dump if I push the test button it will dump sometimes but most times it won’t. The tray has a regular amount of water in it there is no spillage it seems to be a mechanical issue? Is it as simple as replacing the ice making unit in the door?

  • cnorris asked 2 years ago
  • last active 2 years ago
0 votes
1k views

Right door is not closing all the way and keeps popping out. Any videos to fix this issue. Tried hinges, gasket and stoppers nothing working.

  • GeekJames asked 2 years ago
  • last active 2 years ago
0 votes
930 views

After disconnecting the dryer to clean the duct, I removed the front to clean the inside and cleaned the duct. Closed up unit plugged in the unit, flipped on the breaker, and powered up the unit. The dryer is powered up but will not go past the selection/timer. The start/pause is not engaging the cycle.I read in some past posts that it could be a belt or a fuse. What are my next steps?

  • The1Jeff asked 2 years ago
  • last active 2 years ago
0 votes
990 views
  • moses asked 3 years ago
  • last active 3 years ago
0 votes
772 views

Attempted to rewrite control board after compressor replacement only getting failure from jig after attempting rewrite

0 votes
1k views

All of the buttons on the user interface of my refrigerator are dead.

0 votes
849 views

My LG refrigerator is dispensing ice.

0 votes
826 views

My LG refrigerator is not dispensing water.

0 votes
843 views

My LG refrigerator will not start up.

0 votes
837 views

My LG refrigerator is not dispensing ice.

0 votes
901 views

The light does not come on when knocking on the door.

0 votes
874 views

My LG refrigerator is not dispensing ice.

Showing 1 - 30 of 905 results