Brand: Samsung

The fridge is leaking water into the bottom drawer and it is not cooling. I saw the video Samsung RF268ABBP Refrigerator Repair – Fresh food section is leaking water – Sensor. This is the closest to the model I have. Also another one I saw similar is Samsung RF266AEPN Refrigerator Repair – Not cooling properly, freezing up on the back panel – Evaporator and Defrost System. Am I better off trying to replace the sensor or the whole Evaporator and defrost system on my Samsung RF267AERS ?

Thanks in advance for your answer!

My Dishwasher is displaying a AE6 error code.

Question is about this repair: https://www.appliancevideo.com/premium/samsung-dw80j9945us-dishwasher-leaking-from-the-sides-of-the-door-water-wall/

I’m actually having an issue with the 7e error code trying to find information in regards to that replaced the sprayer arm assembly as well as the motor that runs it still giving the same code trying to see if there is a test for it or if I have to run the machine through test mode so that it understands it has a new motor new motor is running the old one would not but it is making a thumping noise like as if it is trying to run one direction to far or the other direction to far

c14 error code

The buttons on my Samsung refrigerator are not responding.

The thermal fuse on heater keeps blowing, the thermostat, fuse, and thermistor have all been replaced but problem persists. We have checked and air flow is not an issue. What else can we do.

Styrofoam insulation for evaporator has become saturated with water from a backed up drain.
Anyone have one I can purchase this part ? DA62-01766A.
Thanks,

—

Found the belt shredded last year and replaced it, but seems to have happened again. How can it be going through them so fast since the customer doesn’t use it on that consistent of a schedule? I can replace the belt again but don’t want to do this every year. and cover the cost of the part if something else is going on.

I am getting a C24 error code on my Samsung refrigerator

SAMSUNG WASHER SERIAL #Y69Q5AEC803568N manufactured august 2012. pump upgrade kit Dc98-01877a – does anyone have (can get) instructions for this kit?

My refrigerator is displaying a c44 error code.

Hello

Why are the Washer suspension rods are bent on this unit? What is the correction.

Thanks Randy

Seems to not be getting consistent power and not running. I’m thinking a bad board. Haven’t been out yet to diagnose it. Thoughts?

Samsung refrigerator dispenser controls not working, all buttons not working. Display has the 3rd led from bottom in freezer section lit. Is it the errror code for bad freezer defrost sensor? Tried to check ohm reading for sensor at pcb, had open circuit. Wire colors did not match tech sheet. CN40-6 was blue not blue/grey.
I have very little experience with Samsung, but does this look like the defrost sensor needs to be replaced? I don’t see any listing of a “defrost sensor” in the Sears parts listing. I see Refrigerator sensor, thermal fuse, fixer fuse, fixer sensor. Which one needs to be replaced?

Over heating condition, Burner does not come back on in Sabbath mode.

My refrigerator is displaying a C13 error.

I am looking for some help on a Samsung SxS refrigerator The original complaint was that the unit wasn’t cooling on either side, neither temp gauge on the display is working, and the Cubed Ice button keeps flashing on the display. I have already replaced the main control board P#DA41-00219K, put in a new condenser fan motor P#DA97-01949A, changed the step down transformer in back P#DA26-00022B, replaced the overload relay on the compressor and that tested OK. Unfortunately after all of these things I’ve tried, the compressor is still not working. Does anyone have any experience or suggestions with this unit? Any help would be much appreciated.

I have some infomation about that error cod,the problem coud be with the electronic control board or could be the heating element. I want to know wich one could be the problem.  The costumers told me just to replace the heating element. Hope is going to fix the problem.  Could you please post a video how to replace the heating element for that dishwasher.  Some, advice how to make easy to replace that thanks so much for the help. Tomorrow i have that service at 9am can you post the video as soon as posible thanks alot.

What are some of the things I should be looking that could cause a 7e error code

I have a Samsung dishwasher that displays a SE or 5E fault. That fault I believe is associated with it not draining but it drains just fine. Every time the error is there the water is pumped out and I can always force it to drain by canceling the cycle. Please let me know if anyone else has had this issue.
Thanks,