TOUCHPAD LIGHTS BECAME GLITCHY FOR TWO LOADS AND THEN STOPPED WORKING. REPLACED TOUCHPAD PANEL, CONTROL BOARD, AND THERMAL FUSE. CLEANED OUT SUMP (NO DEBRIS PASSED THE SCREEN). DOOR LATCH SWITCH HAS CONTINUITY. AT THIS TIME STILL WON’T START AND THE ONLY LIGHTS THAT TURN ON ARE THE SANI-RINSE, HI-TEMP SCRUB, AND HEAT DRY. SUGGESTIONS?
THANKS!
- CraigEbert asked 10 hours ago
Hello
If you replaced everything in this post, I would look at the wiring harness connections at the control board and down by the hinge assembly to make sure there are no pinched wires. If you do not see any pinched wires and you have good connections, go to the technicians diagnostic link below. On page #1 on the lower left you will see (SERVICE DIAGNOSTICS CYCLE NOTES NOTE 1. To invoke the Diagnostics Cycle, perform the following key presses or actions in less than 6 sec while in standby) Try to run the unit through the diagnostic mode. If it will not run through diagnostics, I would replace the wiring harness. You either have a bad harness or a defective new control board.
- AV Repair Help answered 8 hours ago
- You must login to reply
Please login first to submit.
