The unit keeps getting a low water error and everything I could think of checks out: inlet valves, water pressure, fills with correct amount of water, board/panel is fine, cleared some minor debris from the pump, and checked that the float works. What am I missing?
See link to repair video .. https://www.youtube.com/edit?o=U&video_id=8PGBTmfTpMI
We’ve had a couple that the after all else checked out, it ended up being the float switch/housing area was clogged up with some small debris, causing it to not always read the water level correctly, even if there is the proper amount in there. The unit normally quits and won’t finish the cycle until it’s corrected. Then you can clear the errors and run a test cycle. Let us know if this works!
- You must login to reply
Please login first to submit.