GOOD MORNING. I DID NOT CHECK OUT THE UNIT YET, BUT I AM TOLD THAT THE WASHER IS SHOWING THE F07 CODE. ANY INFO WOULD BE GREAT, AS I HAVE NOT SEEN THIS PROBLEM. THANKS, TODD FROM NY.
- Guest asked 7 years ago
Possible Causes for F01 error code
Make sure that both valves at the water source(s) are turned on all the way.
Check for plugged or kinked inlet hoses or plugged screens in the inlet valves.
Verify inlet valve operation.
If there is water in the unit:
Verify drain pump operation.
Verify that the pressure switch hose is in good condition and properly connected to tub and pressure switch.
Remove hose from pressure switch. Dislodge any debris build up in the hose inside the outer tub.
1. Verify there is not a siphon problem.
2. Unplug washer or disconnect power.
3. Verify wire harness connections to inlet valves, pressure switch, drain pump and Central Control Unit (CCU).
4. Check all hoses for possible leaks.
5. Plug in washer or reconnect power
6. Verify pressure switch operation.
7. Verify CCU operation by running a Quick Diagnostic Test or any
See links below
- AV Repair Help answered 7 years ago
-
THANK YOU, BUT THE WASHER IS SHOWING AN F 07 CODE (SEVEN).
- You must login to reply
Please login first to submit.
