Washer lights up and locks in diag mode stops at C 3. When repowered got error code E 1 F6. Replaced control same issue manual is not useful checked power supplies both were okay.
door lock stays lock most times until times out. Won’t go into diagnostics that far very inconsistent results. Never get drain or main stator motor to run …I get a quick shot of 120 at the motor on start up
but nothing on motor test c5. I checked motor ohms and harness to mcu seems good.
what is the next step ?

Model Number

The MCU might be your problem. It is powered as soon as the door locks and the dispenser motor shifts to pre-wash position. Can you successfully make the unit go into spin thru diagnostics?

Showing 1 result
Your Answer

Please first to submit.