A few years old. FE code. Fill error. Checked all fill solenoids they were
good, put in new pressure switch and machine behaved better. I
watched it for 15 minutes and left. Five minutes
after I leave I get a text that the FE is back(happened in rinse cycle).
Anyone know these better than I do?
.
There is no flow meter on this washer, one of the cold water valves must be bad since it happened in a rinse cycle. Check screen on cold water valve for blockage also. Keep in mind, some of these LG washers use DC volts to the water valves.
7-2. QC TEST MODE.
The washer must be empty and the controls must be in the off state.
1. Press the WASH/RINSE and SPIN SPEED buttons simultaneously.
2. Press the Power button, while the above condition. Then buzzer will sound twice.
3. Press the Start/Pause button repeatedly to cycle through the test modes.
7-3. HOW TO CHECK THE WATER LEVEL FREQUENCY
Number of times the
Start/Pause button
is pressed
Check Point Display Status
None
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
Turns on all lamps and locks the door.
Tumble clockwise.
Low speed Spin.
High speed Spin.
Inlet valve for prewash turns on.
Inlet valve for main wash turns on.
Inlet valve for hot water turns on.
Inlet valve for bleach turns on.
Tumble counterclockwise.
Water Temperature (Thermistor)
Drain pump turns on.
Off
rpm (42~50)
rpm (55~65)
rpm (105~115)
Water level frequency (225~265)
Water level frequency (225~265)
Water level frequency (225~265)
Water level frequency(225~265)
rpm (42~50)
Water Temperature [°C]
Water level frequency (225~265)
❋ Press the CUSTOM PROGRAM and PRE-WASH buttons simultaneously.
A display indicating 41 means a water level frequency of 24.1 kHz.
The digits indicate the water level frequency.
➔ ➔
15
7-4. ERROR DISPLAY
- AV Repair Help answered 9 years ago
- You must login to reply
Please login first to submit.
