0
0

FF & FZ not getting cold enough. I would say because the compressor is not staying on long enough. Its a linear compressor. I measured the voltage going to it. 220v when starts and slowly rises to 350v then shuts off o volts. 5 minutes later will start again. compressor is normal temp not burning hot. looked at the main board, its giving 6 flashes. Evap. & Condenser fans stay running. Only the compressor shuts off. voltage at the wall outlet is normal 120v.

Model Number
795.51833.410
Serial Number
503mrpg05024
What have you tried so far?

I tried unplugging the refrigerator for 5min. Restarted it and the compressor was running longer and the board was not giving 6 flashes anymore. I left the job, not sure if it is goin to stay working.

Request Resource Materials
Service diagnostics guide
Refrigerator Kenmore
Share
Filter
Sort by: Newest First
0
0

Hello

       The linear compressor during start up for the first 30  seconds and will be at half stroke intervals. The every .08 seconds it will ramp up to until it hits maximum stroke in 3 minutes and 15 seconds. The complete compressor diagnostics will be on page #111 in the manual link below. You will also find the complete diagnostics in this manual .I advise you run the unit through the complete diagnostics. Matt Ace technician
  • Thank You very much, I will check it out , Jim
Showing 1 result
Your Answer

Please first to submit.