Filter
Sort by: Newest First
0 votes
In reply to: Dryer counts down but does not run

Hello
I believe the fuse you are referring to is in the heating circuit only. I have provided the technician diagnostic manual along with a Service bulletin. See links below Matt Ace technician

0 votes
In reply to: Need Service Manual KitchenAid Refrigerator

Hello
See the technician diagnostics manual link below along with the #76 page Job Aid. Matt Ace technician

0 votes
In reply to: replace gas valve we01x10201

Hello
See the manual link below on the DPGT750 series breakdown along with the wiring diagram and video. Matt Ace technician

0 votes
In reply to: Stops with 17 minutes left.

Hi. What happens when it stops at 17 mins? Does it do anything? Is anything running? Is it full of water, or empty? If it will not advance from 17 mins and you are not getting any error codes, it seems like you would have a faulty control board. Let it sit for 30 mins or more at 17 mins so it has time to pull an error code. Is it trying to spin and going off balance? Attached is the tech sheet. I found no pointers for this issue.

0 votes
In reply to: Unit not cooling to temperature in the refrigerator should be 38 reading 52 and freezer -12 should be 0

Hi. Check what the actual temperature is in the refrigerator. Is it truely 52 or is it reading correct temps? Check your air flow. coming into the ff section. IF your compressor and fans are running, the freezer is correct temp, then you must not be getting air flow to the refrigerator. Check for frost build up on the evaporator which would indicate a defrost issue. Or frost build up in the air passages. Make sure the door seals are good and the light bulb shuts off when the door closes. Attached is the job aid and tech sheet for this unit.

0 votes
In reply to: refrigator ice maker frezzing up

Hi. Is the ice maker not producing ice? Are cubes getting stuck in the ice maker? Or are you having a frost issue in the ice chute and on the ice bucket? IF your issue is frost, warm air is entering the unit. Most likely the ice chute door is not closing/ sealing. Take a look at the ice chute door. IF it needs replaced it is part # W10889430. I have attached the owners manual that will have your warranty info in it and the tech sheet.

0 votes
In reply to: Trim Ring Removal Help

HI. I can not find a video for your exact model. All the videos I find have screws to remove on the bottom trip piece. There could be tabs to release on the bottom. I have attached a video that show tabs on the bottom. This video is not for the same brand so yours would be different. If no tabs on the bottom then there are tabs around the display. You will need something small, like a putty knife to slide into the gap between the door and Display to pry it out, but be careful to not scratch or damage the door. I looked up a picture the the control and is shows two screws on the bottom to remove after the bottom trim is removed so I do not think it would have tabs to get with the putty knife. Also, try taking out the spill tray on the bottom of the dispenser. There will be a screw under it to remove. This may remove the bottom trim and then revel the screws to remove for the upper one.

0 votes
In reply to: Refrigerator not cooling

Hi. Yes, there is a fan in the refrigerator. You will need to replace this fan to fix your issue. I have attached a bulletin for you and the fan. It looks like you do not need to upgrade the software any longer. Just the fan is needed. Double check that your model number is on the bulletin.

0 votes
In reply to: Unit has two ice makers, one in freezer compatment and one on the left fresh food door neither unit is producing

Hello
See Ice maker diagnostics are on page #87 in the link below. Also see the ice maker service bulletin link. I have also provided GFE28 series video’s .

0 votes
In reply to: Ice and Water dispenses intermittently as if a ghost was depressing the paddle

Hi. It sounds like you have an issue with the dispenser module or the user interface control. The dispenser module is p# . I have attached a video for a similar one. The User interface is p# 242041101. Check the switches on your dispenser module. Check that the paddle is not making contact with the switches as well when no one is pressing the paddle.

0 votes
In reply to: Refrigerator 54 degrees

Hello
I have attached the manual for the baffle module diagnostic test. See links below. Matt Ace technician

0 votes
In reply to: Is this a sealed system failure?

Hello
See the service manual links below. Diagnostics are on page #37. As long as the diversion valve is working properly you have a sealed system issue. The diversion valve rarely has issues, you can go through the diagnostics on the valve to be sure.

0 votes
In reply to: Looking for a glass tray

Bellow is a link for the part you are looking for.

0 votes
In reply to: E31 error code

Typically error code E31 on Electrolux models indicates that it has detected an internal generator error on left side cooking zones.

0 votes
In reply to: error code F152

F152 means the right front burner has failed, the sensor in it is bad, the burner will need to be replaced.

0 votes
In reply to: looking for a touch pad

Below is a link for the part you are looking for.

0 votes
In reply to: Need new board

Unfortunately it looks like that main pcb board is no longer available.

0 votes
In reply to: Off balance

I recommend replacing the four suspension rods that keep the tub balanced.

0 votes
In reply to: Looking for tech sheet

Hello
See the technician diagnostic sheet link below. Matt Ace technician

0 votes
In reply to: BOSCH , dishwasher just runs and it won't stop

Hi. I have attached the service manual for you. This manual should be similar to your unit. You can run the diagnostics to see what error codes you get. If the unit will not drain water, you could have a faulty drain pump or a clog in the drain hose.

Showing 2421 - 2440 of 10k results
«1...120121122123124...493»