It is very likely that the inverter is faulty.I have attached a link for the part number you listed. I did not see a fuse on this part to replace. I was trying to look up your model again but the website to look it up on is currently not working.
- Brian, Ace Appliance answered 8 years ago
Hi. Yes the water line is going to be frozen through the door. This is very common for these units to freeze the water line in the door. Just open the freezer door for about 20 mins and the water line will thaw. Keep checking for water flow every 5 mins or so. The issue is with the insulation with in the door. Replacing the door is the only fix. They redesigned the door with better insulation. It will more than likely continue to freeze the water line.
- Brian, Ace Appliance answered 8 years ago
Hi. I have attached the tech sheet for you on a similar unit. The EF error code is for the evaporator fan motor. The issue can be with the fan itself, the wiring or the control board. Even with the fan running and working properly, it may not be sending a proper signal back to the control board.
- Brian, Ace Appliance answered 8 years ago
Hello
See the video link below for the TE error code on your washer model. Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello
See service manual and service bulletin links below. Matt Ace technician
- AV Repair Help answered 8 years ago
Hi. It does not look like there is a fuse. I have attached the service manual for you. Are you getting any error codes? Take a look in the service manual at the error codes to see if you unit is giving any. Take a look at page 6. It has trouble shooting for a burner not working. It will explain and show how to test the unit to find out what is not working. Is that burner still working some of the time. I did a little research and found a lot of these unit have pan detection issues. They are very sensitive on the type of pan being used.
- Brian, Ace Appliance answered 8 years ago
Hello
You are correct they have updated the valve seals to correct this issue. It sounds like you have the new updated valve. I think that you may have low water pressure. I would next replace the inline filter and the saddle valve at the main water supply. I found A service manual close to your model but it is not exact. Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
- last active 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
Hello, see links below for the technician diagnostic sheet,parts, and video.
-Matt Ace technician
- AV Repair Help answered 8 years ago
