0 votes
In reply to: Will not start

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: Leaking water

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: Will not start

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: burning smell

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: No power

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: burning smell

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: No cool

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: knob broken

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: grinding noise

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes

Hi. I have attached the tech sheet on this unit for you. I would run the diagnostics. There is a test for the water valves. See what happens in this test. Also, the tech sheet will show where to test from the main board for voltage to the water valves. You could have a faulty control board if it is not sending out proper power or a faulty control board. I do not see the triac. Is the triac next to the water valve? If so, I have seen triacs go bad on this brand, but they were much older units that this one. I’m not positive, but the the valves should be getting 120V. I do not think I have ever seen one that is supplied with any other voltage other than 120V.

0 votes

Hello
Look at the ( Service Flash ) link below for your model. It sounds like this could be your issue. Matt Ace technician

0 votes
In reply to: Not cold enough

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: Not cooling properly

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: burning smell

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: knob broken

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

0 votes
In reply to: Frost on coil

See links below for the technician mode and complete troubleshooting service manual. You must be logged in to get to the manual links.

Showing 3981 - 4000 of 10k results