Repair Help | Appliance Video

0 votes

In reply to: Both ovens do not self clean

HI. I have attached the service manual for your unit. Take a look at page 50 and 51. This is the wiring diagram for self clean on both ovens. I would think door latch too if you can hear it attempting to latch. It looks like the only thing that would be connected for self clean on both ovens is the timer board. Take a look and see what you think. Page 54 has troubleshooting for self clean that looks like it would be very helpful for you.

Brian, Ace Appliance answered 8 years ago

0 votes

In reply to: Why is the dryer giving me the massage ooling while the first cycle of drying. We just change the heating elemen

Hi. make sure the dryer is not on an air only cycle. make sure heat is selected. Is the unit running and not heating? I have attached the tech sheet for your unit. It has the error codes listed. Follow the information for the error code you are getting. Make sure you have proper 240V coming into the unit and check your hi limit fuse on the heater box to make sure it is good.

Brian, Ace Appliance answered 8 years ago

0 votes

In reply to: Oven bake burner only lites two inches from ignitor.

Hi. Do you think it could be a weak igniter? If it is taking longer than usual for the bake to ignite once the igniter comes on, it is probably the bake igniter. If there is an air shutter on the burner, make sure it is adjusted properly. There is no way to prove that the gas valve is faulty other than process of elimination. The valve can be tested electrically, but we know it is working. If gas pressure to the stove is good and the igniter is not weak then it really only leaves the gas valve. I think you are thinking correctly with the gas valve over the regulator with the cooktop burners working properly. There are not screens in any of the valves I have come across to clean out. I have attached some videos for you as well as the tech sheet for your unit.

Brian, Ace Appliance answered 8 years ago

0 votes

In reply to: Long drying time

Hello
See the srvice bullietin below. If the dryer is not heating , the igniter may not be properly positioned in the burner opening , reposition the igniter assembly. Gently push up on the igniter where the metal bracket wraps around the white ceramic base until the tip of the igniter is even with the burner opening. See complete instructins in the links below. You must be logged in to see the links. Matt Ace technician

AV Repair Help answered 8 years ago

0 votes

In reply to: Replacing Part: KitchenAid Washing Machine Timer WP395491

Hello
Great picture now I can see what you have . In diagram #1 go to the back of the console and you will see a Phillips head screw on the right and left side angled on each side.You should see them if you lean over the top of the console. Remove both of the screws from the console left and right side and it will lift forward. Then to remove the timer knob you MUST engage the timer and turn it COUNTER CLOCKWISE to remove. Then remove the two screws holding in the timer. This is a older model but a great unit. Matt Ace technician

AV Repair Help answered 8 years ago
last active 8 years ago

0 votes

In reply to: Fan making a grinding noise