0 votes
In reply to: Not cooling

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.

0 votes
In reply to: No Power

Good question – I have gone ahead and linked a video below that may assist you

0 votes
In reply to: No ice produced

Good question – I have gone ahead and linked a video below that may assist you

0 votes
In reply to: No display

Based on your question I have located a video linked below that could help you,

0 votes
In reply to: Not cooling

Good question – I have gone ahead and linked a video below that may assist you

0 votes
In reply to: Not cooling properly

Good question – I have gone ahead and linked a video below that may assist you

0 votes

We have an video that could help you. Check out the link below.

0 votes

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.

0 votes
In reply to: F7/E1 error code

I have also attached the tech sheet for this model. The code f7 / e1 is referred to on page 7.

0 votes
In reply to: Leaking water

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.

0 votes

Hello
See technician diagnostic sheet link below . Matt Ace technician

0 votes
In reply to: Not making ice

Based on your question I have located a video linked below that could help you,

0 votes

Based on your question I have located a video linked below that could help you,

0 votes
In reply to: Lid will not unlock

We have an video that could help you. Check out the link below.

0 votes
In reply to: Electrical short

I looked up your model number and found a video that should help you out

0 votes

Hello
The H1 error is a (freezer temperature above 26 degrees ) . This is a above normal temperature issue. You need to run the unit through the diagnostic service mode with the technician sheet link provided below. It could be a number of possibilities including Evaporator Fan, Thermistor, Damper, Condenser fan Motor, Compressor, Sealed system leak , ERC, defrost system. You should show an error when running diagnostics. Matt Ace technician

0 votes
In reply to: Not starting

I looked up your model number and found a video that should help you out

0 votes
In reply to: F11 Error code

Good question – I have gone ahead and linked a video below that may assist you

0 votes
In reply to: Water valve leaking

I looked up your model number and found a video that should help you out

0 votes
In reply to: No Power

We have an video that could help you. Check out the link below.

Showing 5641 - 5660 of 10k results