All Answers

We have an video that could help you. Check out the link below.

We have a video that steps you through this very issue. View the video linked below

Based on your question I have located a video linked below that could help you,

We have a video that steps you through this very issue. View the video linked below

We have a video that steps you through this very issue. View the video linked below

Thank you for your question, watch the video linked blow, it should help

Good question – I have gone ahead and linked a video below that may assist you

I looked up your model number and found a video that should help you out

We have an video that could help you. Check out the link below.

Based on your question I have located a video linked below that could help you,

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.

I looked up your model number and found a video that should help you out

Hello
Are you getting proper voltage in to the unit ? Do you have proper polarity with a good ground ? You said you have power to the control board , do you have 115 volts to the main control board ? Normally proper power in the the board with no display is the main PCB. I have uploaded the diagnostic guide steps in the link below, start on page #8 and double check all of the diagnostic steps to verify before replacing the board. Matt Ace technician

We have a video that steps you through this very issue. View the video linked below

I looked up your model number and found a video that should help you out

Based on your question I have located a video linked below that could help you,

Thank you for your question, watch the video linked blow, it should help

I looked up your model number and found a video that should help you out

Based on your question I have located a video linked below that could help you,

I looked up your model number and found a video that should help you out