All Answers

Good question – I have gone ahead and linked a video below that may assist you

We have an video that could help you. Check out the link below.

Hello
If you cannot get the unit into the diagnostic mode fro the instructions on page #3 of the technician sheet link below. Your only option is to replaced the board as it should always go into diagnostics. I would disconnect power for 5-minutes to reset the board and try one last time before replacing the board. See related video links below Matt Ace technician

We have an video that could help you. Check out the link below.

Hello
Here is the diagnostic sheet.

Matt Ace technician

Hello
See provided information available for the model. Matt Ace technician

Hello
See technician link below. Matt Ace technician

Hello
See requested information link below. Matt Ace technician

Hello
See link below for the technician sheet. Matt Ace technician

Hello
See diagnostics and repair guide .

Matt Ace technician

Hello
Yes, there is a fix for the old plastic tab nut. The new part number kit is DC82-0197X . You will need to have your own lock tight, it does not come with the kit and you definitely need it. See video link below for help . Make sure you put the unit not service mode first , then test mode . This is important to get right because during a normal repair tech MUST use service mode before test mode to avoid deleting saved error codes. Matt Ace technician .

Hello
There is an upgrade kit for this model. See video link below for the S-Hook ( Bush pin ) & bracket upgrade . Part # DC82-01097W KIT . DC82-01097W

Hello
See the service manual for your model. It sounds like you may have a defective spark module. #74004283 . Matt Ace technician

Hello
There is no service bulletins on this model. Is the evaporator completely frosted at a -20 degree coil temperature ? If not this could be a start of a sealed system issue. Is the dispenser ice flap closing 100% of the way ? Is the evaporator fan motor running at the correct speed ? Are your door seals good or is there any shelf or food preventing the doors from closing all of the way ? You could have a damper door issue or thermister not sensing the proper FF temperature. Last is main PCB not functioning properly. I would check all of these issues , then start replacing the lowest price parts after completing the diagnostics.

We have an video that could help you. Check out the link below.

Good question – I have gone ahead and linked a video below that may assist you

Good question – I have gone ahead and linked a video below that may assist you

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.

We have a video that steps you through this very issue. View the video linked below