All Answers

Thank you for your question, watch the video linked blow, it should help

Thanks for asking a question. I looked up that model number and we have a video on a similar issue. I put a link below the answer.

We have an video that could help you. Check out the link below.

Thank you for your question, watch the video linked blow, it should help

We have a video that steps you through this very issue. View the video linked below

Based on your question I have located a video linked below that could help you,

We have an video that could help you. Check out the link below.

We have an video that could help you. Check out the link below.

I looked up your model number and found a video that should help you out

We have an video that could help you. Check out the link below.

Good question – I have gone ahead and linked a video below that may assist you

Thank you for your question, watch the video linked blow, it should help

We have a video that steps you through this very issue. View the video linked below

Thank you for your question, watch the video linked blow, it should help

Hello
It sounds like you have something stuck in the pump or an item stuck between the tub. I would check there first. Matt Ace technician

Hello
See service link below on the correction for ice crystals and water droplets form at the bottom of the ice maker.
The ice room fan has a “c” shaped hole and “c” shaped shaft stopper, which can fall out of correct position when the fan motor stops. Fan motor turns can become slow and noisy or just stop completely. It affects the models below . Matt Ace technician

RF23HCEDB, RF23HCEDT, RF23HSESB, RF23HTEDB, RF23J9011, RF24FSEDB, RF25HMEDB, RF263BEAE, RF263TEAE, RF26J7500, RF28HDEDB, RF28HDEDT, RF28HFEDB, RF28HFEDT, RF28HFPDB, RF28JBEDB, RF30HDEDT, RF31FMEDB, RF31FMESB, RF323TEDB, RF32FMQDB,RF34H9950, RF34H9960, ALL COLORS, Part number: DA81-05595A

Hello
When F:01 flashes there is a primary control board issue . See diagnostic sheet below.

Matt Ace technician

Hello
We currently do not support Summit appliances. I did find a user manual link below if this helps. Matt Ace technician

Hello
See service manual provided for your refrigerator. We use a refrigerant scale to weigh in the exact refrigerant charge based on the manufactures recommendation. Matt Ace technician

Here is another link. If you look at the lower right portion there is a reference to error codes for you.