All Answers

HI. I have attached the tech sheet on your unit. I would run the diagnostics first and check for any error codes. THen you can also try and Start a forced defrost cycle. Then tech sheet also shows the control board and where to test your defrost components from the board. You could also take apart the back panel off to gain access to the evaporator, to test the defrost components.

I recommend installing a new ice maker on this unit. See links below.

I recommend installing a new inlet valve on this unit, also make sure the valve and hose screens are not clogged with debris.See links below.

I recommend installing a new cold control on this unit. See links below.

I recommend installing a new shift actuator on this unit. See links below.

I recommend installing a new door latch assembly on this unit.See links below.

I recommend replacing the lid latch assembly on this unit.See links below

I recommend replacing the drive motor on this unit. See parts links below.

The ( H ) error is a control board error . I recommend installing a new main control board on this unit. See links below.

Check for power into the unit. Also check for proper ground and polarity .If all is good I recommend replacing the main control board on this unit. See links below.

I would start by replacing the lid switch on this unit. Very common issue. See parts and video links below.

Sounds like a defrost issue problem . I recommend replacing the defrost heater on this unit. It is the most coomon problem beside the defrost control. See parts and video links below.

Do you have water in the ice maker ? If you have no water in the shell of the ice maker I recommend replacing your saddle valve . See links below.

I recommend replacing the smart board on this unit. See links below.

I recommend installing a new heat pump on this unit. See parts and video links below.

I recommend replacing the main control board on this unit. See links below.

I recommend replacing the timer on this unit. See links below.

I recommend replacing the pump and spin bearing on this unit. See parts and video links below.

I recommend installing a new ice maker on this unit. See parts and video links below.

Can you send me a link to that video you saw so I can clarify what Robert was talking about? I responded to that question and I still think it could be glitched up because of the ice maker or needs a control board.