All Answers

Hi. I had this happen to me before after I installed a capacitor. I put the wires back on correctly, but I put the diode on the opposite side on the cap which was causing the issue. If all your wiring is good and nothing is shorted to ground, I would check the door switches next.

I would recommend to check your evaporator fan motor to see if it is running. Then step two if you here the evaporator fan motor running see if the compressor is running. Let me know what you find and we can proceed forward.

I would recommend replacing the main board on this unit. This is a very common issue for this model. See parts and video links below.

The noise could be the bake element breaking or popping. See if you see any burn spots on the element if you do I would recommend replacing the bake element on this unit.See parts and video links below.

This is a heat release ice maker. What are you looking to accomplish? If you remove the ice maker cover from the head of the ice maker you will see 5 holes which have letters next to them. These ports are where you can test the ice maker from. You can check the ice maker and the fill valve from here. Exp: M to N or T to N with an insulated jumper wire will force a harvest when the door switch is closed, you can check the valve being energized now by using your meter set to AC at ports V to N. This happens at the end of the harvest cycle. L to N shows you if there is power to the ice maker. Please let me know if you need more assistance.

I would start by replacing the bake ignitor on this unit. See parts and video links below

I would recommend clearing out the disposal and making sure the dishwasher drain line is secure.

I would recommend replacing the ATC switch. See parts and video links below.

I would recommend replacing the front drum bearing on this unit.

I would recommend installing a new bake ignitor on this unit.

I would recommend installing a new blower wheel on this unit.See parts and video links below.

I would recommend replacing the bake ignitor on this unit. See parts and video links below.

I would recommend resetting the control on this unit.

I would recommend installing a new saddle valve on this unit.

In my experience this problem can usually be rectified with the instillation of a new control board.

I would recommend replacing the motor pump assembly on this unit. See parts and video links below.

I would recommend installing a new saddle valve and clearing any debris from the water line.

I would recommend installing a new bellow on this unit.

I would recommend installing a new heater and defrosting the evaporator.

In my opinion this unit needs a new lid switch. See parts and video links below