All Answers

In my experience with this unit installing a new ignitor will usually rectify the problem. You also may need to repair the wire terminals at the flame sensor. See link for parts below.

From your symptom it sounds like it needs new igniter and four front bearing glides. See parts link below.

From the symptom you are explaining it sounds like the unit needs new cam kit. See parts link below.

Unit may need idler pulley and belt. Also may need debris cleared from vent.

Unit needs main control board if its coming on and beeping on its own. See link below to control board.

With your symptom it most likely needs heating element see link below to your part number .

If its frosted in the freezer section on the back coil . Most likely needs fresh food evaporator defrost termination or main control board.

Unit most likely has broken drain pump that is plugged and not draining. This will make the unit run constantly as it is trying to drain.

In most cases you will need to replace water guide assembly. That is the most common issue.

Unit most likely needs control. See link below for PBC assembly control .

In my experience with this unit having this problem the unit most likely needs a cold water solenoid and drain pump.

in my experience with this unit having the same problem in the past it needs a new bet,front left support roller, and the hi-limit thermal-stat

This unit most likely needs a new door latch.

In my experience with this unit a new spark module will usually rectify the problem.

In my past experiences i have found that when this unit stops heating a new main control board will usually rectify the issue.

I have run into this problem before and i have found that removing extra sceens from the inlet hoses and leveling the unit will rectify the problem in most cases.

It is common for this type of drain pump to get coins and other debris stuck inside of it causing it to malfunction.

We have found that most units need a new fresh food evaporator when having this issue. evaporator part number is 4204400.

In most cases we found that the rotor and rotor belt goes bad on this model. Here are the two part numbers for this model. The rotor part number is 4413er1003a and the bolt part number is 4040fr4051c. Hope this helps, Matt ace technician

What type of problem or symptom are you having with this Kenmore washer ? Matt Ace technician