All Answers

This sounds like an issue with the dispenser solenoid. Here is the part number. WR62X23154. Below is a link to the repair video.

The defrost heater likely needs to be replaced. Here is the part number for the heater.WR51X10055 Below is a link to the repair video for the heater.

The LED light board likely needs to be replaced. Here is the part number for the light board. WR55X26671. Below is a link to the repair video for the board.

The issue is likely with the electronic control. Here is the part number. WR55X31697. Below is a link to the repair video for the control.

The issue is likely with the water inlet valve. Here is the part number. WR57X30891 Below is a link to the repair video for the inlet valve.

The issue is likely with the start relay. Here is the part number for the relay. WR08X21100. Below is a link to the repair video.

The issue is likely with the condenser fan motor. Here is the part number for the motor. WR60X10209 Below is a link to the repair video.

The issue is likely with the dispenser interface. Here is the part number for the interface. WR55X30704 Below is the link to the repair video.

Hello
We do not have a video for this tub replacement currently. We do have the training manual for your model. Go to Tub & Basket removal page #18 in the link below .This will show you step by step on the removal process.

Hello
This is likely a problem with one of your latch motor switches. We have to determine which oven latch or switch is giving you the issue. We have attached the parts diagram and the wiring diagram for you to use as reference. Let’s start by first checking the self clean function of both ovens one at a time. Try the upper oven first and see if the latch will operate and if the cycle will function. If everything is working after approximately 30 minutes then cancel the cycle and repeat process with the lower oven. Hopefully on of those ovens will fail to operate the self clean lock function which will lead us to the proper latch. If both latches function properly and unlock after the cooling down period then we may have an oven relay board failure. Please take the initial steps and keep us posted.

The issue is likely with the dispenser chute solenoid. Here is the part number. WR62X10055. Below is a link to the repair video for the solenoid.

This sounds like an issue with the dispenser micro switch. Here is the part number for the switch WR23X10783. Below is a link to the repair video for the dispenser.

The issue is likely with the dispenser light board. Here is the part number. WR55X10899. Below is the repair video for the board.

This sounds like an issue with the spray arm. Here is the part number for the spray arm.W10884490 Below is a link to the repair video.

The issue is likely with the door spring. Here is the part number for the spring. WP8270020. Below is a link to the repair video for the spring.

The issue is most likely with the water inlet port. Here is the part number for the water inlet port.W10584470. Below is a link to the repair video.

The issue is likely with the heater. Here is the part number for the heater. AEG33121504. Below is the link to the repair video for the heater.

This sounds like an issue with the control panel. Her is the part number for the panel. W11123145. Bellow is the repair video for the control panel.

The issue is likely with the electronic control. Here is the part number for the control. W10802078. Bellow is a link to the repair video for the control.

Hello
See the complete service manual, troubleshooting and wiring diagram links below.

  The FL error code can be a few possibilities. 

1) The door lock switch is not connected correctly.
2) The door lock terminal is broken.
3) The main ( PCB ) Power control board is defective and needs replacement.