All Answers

nd indicates that you have a drain error. It is either an issue with the drain hose installation or an issue with the drain pump itself.

The dC code indicates an unbalance error.

E24 idicates an overheating error.

This is most likely an issue with the Heater Temperature Sensor Main PCB

E-22 indicates a short in the thermal sensor.

this indicates an issue with the thermal Sensor.

The SE error code indicates a wiring issue. Usually a problem with the ribbon cable.

That error code indicates a temperature sensor short.

E08 is a broil or Bake Heating Error.

“EOA” is an overheat error.

The SE error code indicates that you have a shorted key. 1. Take out keypad from the main PCB. 2. Check whether between connector(CN05) pin and pin on main PCB have a short circuit. 3. If there isn’t a shorted area between the Keypad, replace or repair keypad. 4. If there is no problem with the connector on main PCB and cable of keypad, replace the Main PCB

The is a communication error

dE is a “door open warning”

That is a button error.

This error occurs when overflow detection AD data is 3.5V or below for 3 seconds.

A C86 is a Comp over voltage error

C85 is a Comp low voltage error

C84 Motor Locked / Over RPM

C83 Comp location detection error

The error code is displayed when the compressor IPM fault error has occurred. Check if there is a short between compressor terminals.