All Answers

Hello
Here is the service diagnostic information links below. We do not have a video on this model. Matt Ace technician

Hello
See links below for service manuals. Matt Ace technician

Hello
F6e6 Error is a water temp code, the incoming water from the house is too cold. See the technician diagnostic manual for you model link below.

Hi. I have attached the tech sheet for you. It sounds like you paddle is sticking or is faulty. If you press the paddle again will it shut off? How long is it running before it stops? It looks like you have just the one paddle to dispense ice and water. Does the water continue to run as well? If the auger is the only one staying on and it does not shut off you could have a stuck relay on the control board. Looks like the main control would control the auger. p# WPW10259858 The paddle is no longer available. It is p # W10176456. The dispenser cover assembly would include the paddle but this par is no longer available as well. It is p # W10179005

Hi. I have attached some repair videos on a similar washer. I have also attached a service bulletin for a control board update for a no spin issue as well.

Here are some videos on this ice maker.

Hello
See manual link with wiring diagrams on page #36.
Matt Ace technician

Hi. I was not able to look up this model number. Please double check your model number. What was your issue? Did you replace the control board and now it needs programmed? I did locate a service manual with a portion of the model number listed. I attached the service manual for you.

Hi. I have ran into this before. The diverter needs to be replaced to stop the leak, even though the new sump with a new seal has been replaced. I have replaced a few diverters to stop units from leaking.

Hello
I have sent you the technician diagnostic guide. You will be able to test the ice maker and water inlet valve with this diagnostic sheet. See link below. Matt Ace technician

Hello
See technician sheet link below. F-01 error is primary control failure. Matt Ace technician

Hello
On this cover you have 3- harnesses:
1) First harness for the evaporator fan motor
2) Second harness for evaporator fan on another model , you only plug in the harness that fits your motor. Leave the other unplugged.
3) Third harness is for refrigerator temperature sensor .

You do not have a heater on the grill assembly.

Matt Ace technician

Hello
Se the technician manual link below. Then look on page #38 you will see the times for the convection bake element and fan assembly.
Settings for convection fan :
1) Convection Roast – Fan runs all of the time.
2) Convection Multi-Rack – Fan runs 40 seconds shuts off for 10 seconds
3) Convection Single rack – Fan runs counter- clockwise 3- minutes shuts off for 10 seconds the runs clockwise 3- min
4) Proof setting – Runs counter- clockwise 1- minute off 10 seconds

This may be running normal so make sure you verify the manual before replacing parts . Matt Ace technician

Hi. I have attached a service bulletin that may apply to your issue as well as a service manual for this unit.

Hi. I have attached the service manual and tech sheet for this washer. The F01 error is a CCU error.
CCU ERROR
Communication error within the Central Control Unit
(CCU); the pump drive in CCU fails to activate; one of
the main relays in the CCU fails to activate

Hello
See the service manual link along with a service bulletin that could possibly be your issue. Matt Ace technician

HI. I have attached the service manual for this style washer.

Hello
See the service manual and wiring diagram links below. Also see the service bulletin on ice maker . Matt Ace technician