Appliance Type: Dishwasher

Over or leak water.

Will not end cycle.

Leaking water.

Not drying.

Soap does not dispense, Poor drying.

Unit will not start a cycle, No display.

Leaking water.

Leaking water.

Unit does not start.

Door will not shut.

No power to the PCB Main or Control Panel.

Short in the wash motor, Tripped a breaker, NE, LE Error Codes.

No heat condition.

Noisy operation No drain, or a water leak on the right side, 0E Error Code.

Short fill, or a water leak on the left side, FE, 1E Error Codes.

Short fill, or a water leak on the left side, FE, 1E Error Codes.

Missing LED digits from the display.

Water dripping on the left side front

It will not change cycle to cycle.

Large droplets of water on the sides.

Steam from around the sides, E1, AE error codes.

The LED display will blink and not start cycle.

Metal sound when opening and closing the door.

I checked ALL of the “how to” websites looking for this particular part # to change out. I found NOTHING !!!
The complaint is that the dishwasher ONLY pumps out water. It does nothing else. I checked out the possible problem(s) and found that it is or could be a bad water sensor. Especially with this model number.

LG dishwasher will intermittently show a drain error code. When this happens the machine will just sit and do nothing. If restarted it will run the cycle.

This is a Hobart commercial dishwasher. The cycle runs fine it washes, it drains, rinses and drains. The next morning there will be standing water in the bottom. A slow trickle can be seen coming from the inlet tube. Is there anything except a leaking inlet valve that could be causing this problem?
Andy

Leaks water, humming sound, dishes are not getting clean.

Leaks water, dishes are not getting clean, soap does not disolve.

Standing water, leaking water, bad smell.