0 votes
2k views

Dispenser Problem/ Repost from yesterday
Refrigerator Frigidaire
Unexpectantly the dispenser hatch rapidly opens and closes and if the dispenser is set to water it comes out each time the dispenser opens and closes. What is the cause of this problem? The customer said she googled it and found it is a common compalint. Is this so?

The main problem is NOT trickling water but that whenever the dispenser WANT’S TO; ALL ON IT’S OWN ACCORD it , at any time opens and closes its hatch over and over for several second’s then stops. Without ryme or reason. Wouldn’t this be a circuit board issue? and call for replacing it?

I replaced the dispenser module first and that didn’t help at all. Then I reinstalled the old one and replaced the main control board, and that seemed to fix it then after three trouble free days then it started again. Now what do I do? Is the display a possible cause? It is almost $500.00. Any other ways to try to determine what is the problem?

This dispenser module you sent is the one I replaced. 242100019 Sorry for the confustion. Any other suggestions

Does this question goes against my quota?

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

At start of cycle door locks then pauses . at times it won’t release. I cannot get the service test to activate. Which is the left button under the display? There instructions are very confusing. I have the tech sheet but a service manual may help. Any videos on this would help especially on the diagnostic mode.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

If you weeks ago they received the SYEF error code.
I changed the fan and it was working fine.
Now the temperature rises in the freezer 221 degrees or 18 the stuff are cold the freezer is not full but the temperature keeps on adjusting.
Please advise

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

WE HAVE A STACK UNIT WHERE THE WASHER WILL NOT START, NO TECH SHEET

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

how to put in defrost mode in fresh food ice room? ice room evaporator keeps icing up

  • joeski1369 asked 5 years ago
  • last active 5 years ago
0 votes
994 views

This is is a Frigidaire oven this the door lock error? Which board controls it if it is,? How can I check this issue?
I need a service manual and tech sheet and your expert advice.

  • Guest asked 3 years ago
  • last active 3 years ago
0 votes
3k views

I would like to know if all these refrigerators are setup to accept ice makers or do I have to drill holes?

  • Gary Grzechowiak asked 10 years ago
  • last active 10 years ago
0 votes
2k views

The outer door panel is broken and prevents the door from closing properly. Since the outside panel was broken, it came off easily. Now I am trying to put it back on. What is the best way to put the door back on? It appears the door needs to be disassembled so it will fit around the door hinge.

Thanks

  • Steve McGill asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Hi, I would like to follow the repair instructions from this video: https://www.youtube.com/watch?v=k1KEfcNfcMo

But I do not know which tools to purchase, could you tell me the name of the tools used?

Thank you!

  • Julianne asked 9 years ago
  • last active 9 years ago
0 votes
2k views

I changed the door gasket thinking it would fix it, but doesn’t seem to be sitting correctly.

  • Robert C. asked 9 years ago
  • last active 9 years ago
0 votes
3k views

Serial: 4A43011509

Ice clumps in ice bucket every 3 days.

Brand New SxS Frigidaire fridge. No leaks from ice maker. Zero degrees in Freezer with good evaporator fan airflow. Ice dispenser Door and Freezer door close nicely. I thought maybe the icemaker heater was sticking on so I replaced ice maker with now improvement. Within a couple days they call back and all the ice cubes are frozen together. Any Ideas would be greatly appreciated.

0 votes
2k views

Cannot find info on box bag is empty. Comp. was not running when I arrived at house. I unplugged box and plugged it back in. Comp and cond. fan came on and box started to cool. Lady called 4 hours latter . She said it was making ice but the #4 is still flashing and she said the ff is only down to 48. Any idea what the flashing 4 means.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

My Frigidaire dryer is not drying clothes properly.

0 votes
2k views

I’m getting e5e. How do I check what the issue is

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
2k views

My Frigidaire refrigerator is not making ice. Any suggestions?

0 votes
2k views

Looking for tuturial or video to access defrost bi metal in freezer. Steve

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
2k views

i need a service manual for this beast. I need to know how to adjust the freezer door

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
2k views

I need a service manual, I have a parts breakdown, in self diagnostics, I’m getting error code iFO, was told by Tech. line(with customers assistance) that meant overfill, needed pressure sensor, ordered part, went back to diagnostics, first code iFO, second code i60, third i00,. What are second and third codes? I don’t have access to tech. line anymore.

  • joeski1369 asked 8 years ago
  • last active 8 years ago
0 votes
2k views

Do you have any video on how to change a cooling fan on a Frigidaire oven, part # 318575600 ?

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

I want to know how to test the components for this problem.

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
1k views

Dispenser Problem/ Repost from yesterday
Refrigerator Frigidaire
Unexpectantly the dispenser hatch rapidly opens and closes and if the dispenser is set to water it comes out each time the dispenser opens and closes. What is the cause of this problem? The customer said she googled it and found it is a common compalint. Is this so?

The main problem is NOT trickling water but that whenever the dispenser WANT’S TO; ALL ON IT’S OWN ACCORD it , at any time opens and closes its hatch over and over for several second’s then stops. Without ryme or reason. Wouldn’t this be a circuit board issue? and call for replacing it?

I replaced the dispenser module first and that didn’t help at all. Then I reinstalled the old one and replaced the main control board, and that seemed to fix it then after three trouble free days then it started again. Now what do I do? Is the display a possible cause? It is almost $500.00. Any other ways to try to determine what is the problem?

This dispenser module you sent is the one I replaced. 242100019 Sorry for the confustion. Any other suggestions

Did you and the factory technicians determine what is causing this?

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

I need to wiring diagram for this unit, I am having an issue with the power supply to the water valve. Every time the ice maker goes into a fill the water comes out of the dispenser. When you press the water dispenser the water comes out as well.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

The thermistor on the ice maker was ripped off and it shorted out the control board. The unit was completely dead and there was a visible short on the board. I replaced the board and the ice maker and the refrigerator resumed normal function besides the ice maker not producing ice, and water is pooling up in the bin. Not sure if the short could have shorted out the water valve too or not.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

My dishwasher is showing an ER response on the digital readout…It will not allow me to cancel out the normal wash to return to no readout on the readout. It keeps telling me to add spot additive; I did this, but it keeps blinking. It makes a running sound and says washing/drying, but nothing is happening.

0 votes
1k views

MY FRIGIDAIRE DISHWASHER SPRAY ARMS ARE NOT SPINNING. SO DISHES ARE NOT GETTING CLEAN THERE IS WATER COMING OUT OF ALL THE ARMS BUT THEY ARE NOT SPINNING.

0 votes
1k views

I have a frigidaire refrigerator that I’m working, at first it was completely dead. Since I’ve been working on it I have changed out the mother board, the temperature control board, the thermostat, and start device and capacitor. Now I have power going through the unit. The compressor turns on the condenser fan runs and I see a reading on the temperature display. The down fall is after 10 seconds the lights in the fridge start flashing and around 40-50 seconds the compressor shuts off. What could be the cause of this? The only 3 things I haven’t replaced is the thermistor compressor and evap fan.

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
1k views

Frigidaire model#GLFH21F8HWE

  • Guest asked 3 years ago
  • last active 3 years ago
Showing 61 - 90 of 395 results