I have an issue with a Oven, it’s a Kenmore and this is the problem I am seeing: Door not properly closing
- Fred Abernethy asked 9 years ago
- last active 9 years ago
We are serviceing a Kenmore Elite gas dryer that doesn’t dry the cloths. The Thermostat Assembly was replced but the problem continues, should the Thurmistor also be replaced or could something else be causing this problem? Any suggestions on how to proceed?
- mytechjoe asked 9 years ago
- last active 9 years ago
I have this Kenmore (LG) refrigerator that the cust. had the freezer door open for an extended time to clean. After cleaning the alarm continues to go off and the evap fan motor is not running. I assume this is the door alarm, but the doors were closed. The evaporator fan is not running and the freezer light is not working. Compressor and condenser fan works. I reset the unit and the fan started working and the beeping went away.Freezer light working too. Within 12 hours the beeping came back and the fan is not running again. No error codes. I can not find any tech sheet or information on this one. I tested the freezer door switch and it tested fine.
- Brian, Ace Appliance asked 9 years ago
- last active 9 years ago
I need to put this dryer into diagnosis mode, but the tech before me took it for his collection. Any help would appreciated. Thanks Ricky
- Apache Warrior asked 9 years ago
- last active 9 years ago
We are servicing a Kenmore dryer that when turned off all lights turn on and a beeping noise starts. Any ideas of what could be causing this, where to start looking?
- mytechjoe asked 9 years ago
- last active 9 years ago
the unit is getting power.
however the display and buttons to start or select do not respond.
it remains blank
- Guest asked 9 years ago
- last active 9 years ago
- Guest asked 9 years ago
- last active 9 years ago
I have a Kenmore Dishwasher that is not working
- Harley Clark asked 9 years ago
- last active 9 years ago
the washer will intermediately overfill with water.
sometimes during the Rinse cycle.
and sometimes it will work perfectly
- Guest asked 9 years ago
- last active 9 years ago
Have a sears kenmore range, not broiling but bake and convection are working.
Broiler unit has no 220 volts but ohms ok, the range has no wiring schematic.
all else working ok. probably a control but want to be sure there isn’t some fuse or thermo in circuit with broil element. Anyone have a wiring diagraming they can share
Thanks in advance
- Hall Refrigeration asked 9 years ago
- last active 9 years ago
I have a Kenmore Refrigerator that is not working.
- Harley Clark asked 9 years ago
- last active 9 years ago
Burner replacement need to know how to open the cook top a video would help?
- Guest asked 9 years ago
- last active 9 years ago
This is a side by side and the tube to the water dispenser at the freezer door hing has a leak. The leak is about one inch up in side the door. The whole tube will need to be replaced. How do I get the dispenser out with out harm to the stainless steel door? Can I get the whole tube and is there a video on this repair?
- Guest asked 9 years ago
- last active 9 years ago
the ice maker stopped working I am not getting 120V to the ice maker.
I did test the wires coming out of the wall and I got around 60v
- Guest asked 9 years ago
- last active 9 years ago
the machine will keep on running.
I pushed the cancel and I hear the pump continue to run
- Guest asked 9 years ago
- last active 9 years ago
I am having a problem with my Kenmore refrigerator. It is not cooling properly in the fresh food section.
- Don Kopecky asked 9 years ago
- last active 9 years ago
My Kenmore refrigerator is running very loud.
- Fred Abernethy asked 9 years ago
- last active 9 years ago
- Guest asked 9 years ago
- last active 9 years ago
- Guest asked 9 years ago
- last active 9 years ago
- Guest asked 9 years ago
- last active 9 years ago
the unit will fill.
but act’s a bit strange wehn I close the lid it stops
the unit will fill and fill but will not agitate or spin.
the lid lock will lock.
I tried to turn the tube by the belt but it will not move.
I did hear the tube try to turn but all I did hear after was a clicking noise
- Guest asked 9 years ago
- last active 9 years ago
i can not turn the tub by hand
and nothing happens when i turn the unit on.
the timer will display the time for the cycle but that it
- Guest asked 9 years ago
- last active 9 years ago
the unit will not advance.
no water will come in the tub will not turn ( not evan by hand).
will not drain
- Guest asked 9 years ago
- last active 9 years ago
The washer will stop mid-cycle and lock.
Washer was getting a DL error. We changed the lid lock assembly and shock absorbers, the washer worked for one cycle, then the next it started doing the same thing again.
- Apache Warrior asked 9 years ago
- last active 9 years ago
from time to time cooking time will appear on the screen the microwave will not be working.
just the numbers will appear.
- Guest asked 9 years ago
- last active 9 years ago
the two lights were and the unit would not do anything.
I turned of the power and disconnected the ribbon and then reconnected it.
the unit started to work.
buy I still see the lights slightly on
- Guest asked 9 years ago
- last active 9 years ago
the unit is making ice.
however the auger is not turning to dispense it.
- Guest asked 9 years ago
- last active 9 years ago
All features of the stove work. the only thing left to repair is the element light, which stays on
- Guest asked 9 years ago
- last active 9 years ago