Brand: Maytag

making load noise during high spin

Maytag Neptune washer model# MAH4000AWW – starts and stops:
This unit has a timer and a motor control board and a push start button. When you place the timer on any load size and press the start button, the washer begins and fills with water. Once filed the unit shuts off. It does not advance, the timer is not ticking like any egg timer or moving through the cycle at all. If you press the on/off button again it will fill with a little water but stops and turns off.
The motor control board and the time are both expensive. Too expensive to replace both, but i am having trouble separating out which one it may be. I am not looking to the motor because the timer is not advancing at all or should it be, I am not sure.

my refrigerator isn’t working not cooling in the freezer isn’t freezing anything you can hear the noise like it’s working but is not doing a thing

Hello I am looking for the timer ,part#308222
It is a Maytag dryer ,mod.#LDG7400AAW
The part is NLA any suggestions ?

I have a customer with a Maytag Gas Range, MGR7775WS 2, R10414233. This unit doesn’t have an ignitor but has a spark mule for the lower oven and it doesn’t always light on the first try. Is this something to worry about and is there anything that can be done about it?

In the bottom oven the bake element doesn’t glow, it heats slightly though. The element itself tested good. As it is trying to heat a clicking noise comes from the back. Could this be the thermostat or something in the control panel?

washer vibrates badly and walks across the floor. Washer is
level, floor is solid and all suspension springs are good. I noticed
that the tub is rather stiff, by that I mean when I pull or push it one
way or the other it will stay wherever I put it and will stay there even
when spinning. Any suggestion on how to fix the problem will be
appreciated. Thank you.

I just changed both hinges on the oven door but there is still a fill finger gap between the door and oven on the left (when facing the oven) side of the door and you can fee much more heat there than on the right side. Wonder what other issues this could be? I have a new gasket as well. Could the door be warped? Thanks!

We had it stacked at our old place, and it’s been in storage for about a year. We unloaded them here and put them on individual pedestals since we have the room but it seems to not even want to stay on it’s stand. I’m afraid it’ll come right off one of these times on a spin cycle. Any advice for us?

The dryer is not producing heat. I took the heating element out and the coil doesn’t seem broke anywhere. Should I still replace it or is something else causing the problem?

Thank you
Dustin

Can I turn my freezer to power 0 and leave the refrigerator part on in order to thaw out the frozen drain line and pan? Hopefully that way I don’t have to remove all the parts like in the video.

maytag epic front loading washer will not spin on high. door knock works. drains fine. spins but never goes into high spin.

I have a couple elements that have gone out on my stove. Is this pretty easy to do myself if I buy the parts? Don’t want to put a lot of money into this thing cause we’re moving soon. Couldn’t find a video so hoping somebody there can.

My washing machine fills up but doesn’t actually start. I came down hours later to find it had never began the load I put in. I was able to restart it and it worked all day yesterday. Just came down to find the same thing today. Why would it work sometimes and not others?

We have had our Maytag dishwasher for a few years. The door will not open. The latch seems lose and it you try to open it, the latch get pushed up and jammed. Is there a way to open the door so I can check the latch?

I am looking for a way to access my drain pump as I’m getting error code E01 & F09. I see one of your videos that shows removing the kick panel to get to the pump but my washer doesn’t have a kick panel, it has an entire front face panel.

keeps blowing fuses

My washing machine is making a horrible loud & grinding noise through the the rinse and spin cycles and I’m not sure where we should even begin to find out what’s wrong. I watched a few videos but none of the noises sounded similar and I’m not sure what to look for. Thanks in advance for any help with this.

I was washing a load of clothes today and my washer started making an extreamly loud clicking noise but it is only making this noise while the drum is spinning the faster it spins the louder it get please help!!

The washer was leaking water due to pressure value at the drain pump came off. I put it back on and now it has no leak, it drains water but it will not spin or tumble, it got LR error. How do I do further diangostic on this ? Where do I get the diangostic TECH SHEET ? Is the reset button or circuit breaker need to be reset in the washer ? Please help

Freezer seems to be working fine but everything in my fridge is frosting up and freezing no matter what temperature setting I put it on. What is going on?

Something seems bound up. The motor is making an electrical hum noise and it’s pulling alot of current (my lights are dimming). A self reseting circuit breaker soon trips after about 15 seconds of this. I flipped the unit over and the big pully would only turn in one direction. After a few rotations, it seemed free and turned in both directions. I flipped the unit back upright and plugged it in, but it still would not spin. Should I be able to spin the drum by hand? It will not turn either direction now. Any ideas what it is?

I own a Maytag refrigerator Model MFI2269VEW, 2 years old. The icemaker is not making ice but water is coming through the dispenser. Since water is coming through the dispenser would it be the ice maker itself or something else? It is connected to a reverse osmosis system and the refrigerator filter is still in place. I turned the on/off switch off, then on, and the arm did work and reset but I still didn’t hear water fill icemaker mold. My wife and I haven’t used the icemaker that much the last few months.

Thanks

everytime i try to wash my clothes it’ll spin once and 3 mins later it will say R-09. please help

Maytag washer starts spinning clockwise during the agitation cycle then overflows.
During the agitation cycle the tub goes from the small jerks into a fast clockwise spin.
Help?

Hi, My refrigerator leaks when ice builds up on the bottom of the freezer. I have seen a couple of your videos about what the problem is but I cannot find one regarding my Maytag. Is there a solution to the Maytag problem? I have no water line or ice maker on the unit. I saw one video for a Whirlpool freezer that looks close to the Maytag. Are these the same? I know everyone owns everyone else these days. https://www.appliancevideo.com/update-drain-fix-kit-whirlpool-refrigerator-water-leaking/

Thank you.

I have a double oven maytag and my bottom oven will not heat up when I turn it on to preheat it stays at 100 degrees. I replaced the bake element so why won’t my oven heat up?

Its is connected to power.no .nothing. need to diagnose