My GE microwave will not shut off.
- Patrick's Appliance Service asked 8 years ago
- last active 8 years ago
Does everything but heat(no heat).
Would these give quartz heat and Mag heat/ one without the other? Would it heat at all if the Mag is down?
Thanks,
- Curtis Appliance Repair asked 9 years ago
- last active 9 years ago
it seems that the microwave needs a new mag tube and diode.
- Guest asked 7 years ago
- last active 7 years ago
No power at all, already checked the fuse and it’s good.
- mdhomeservices asked 5 years ago
- last active 5 years ago
Is there a way to do a self diagnostic on this microwave via the control panel or otherwise? I was using it the other day and heard a loud bang, and then it stopped heating (although the lights still come on, the turntable cycles, etc)?
Also, via any self-diagnostic mechanism (if available), is there a way to get the serial number and in-service date or anything like that? This was installed in a house I bought but it doesn’t have the serial number anywhere on the machine and when I called Kitchenaid to determine if this is still covered under warranty they needed the serial number to find out but otherwise didn’t offer any help as far as locating the serial # if the label has been removed (which appears to be the case)…
- al asked 10 years ago
- last active 10 years ago
Didn’t find a whole lot if info on this model. It’s not starting and keeps saying the door is open even when it is opened & closed repeatedly. Door is tight, seems to latch fine, the handle isn’t broken. Just won’t get going. Is this a magnetron issue or diode? I saw a lot of those repairs but am just not sure. I don’t work on these enough to know definitively. Appreciate the help.
- Curtis Appliance Repair asked 9 years ago
- last active 9 years ago
Has SE error code any suggestions ?
- Patrick's Appliance Service asked 8 years ago
- last active 8 years ago
The microwave won’t start, what could be the problem?
- Guest asked 8 years ago
- last active 8 years ago
My GE microwave is getting power to it but will not start.
- Fred Abernethy asked 8 years ago
- last active 8 years ago
My customer has a GE Profile JVM2070SH001 Microwave and reports that the lights on the touch pad light up when the door is opened but non of the buttons will work when trying to start the microwave cooking cycle. any ideas will be appreciated.
- Keith Nelson asked 7 years ago
- last active 7 years ago
How do I access all the components to fix magnetron diode fan capacitor and HV CAPACITOR.
- Guest asked 7 years ago
- last active 7 years ago
Ordered both tension rods. Installed new ones door still falls.
- Guest asked 7 years ago
- last active 7 years ago
Hello I have a customer call kitchen aid microwave issue only half of the LED display is lite, and the micowave wont start when push start button customer says he reset main breaker and the micowave will work properly for awhile. Have no imformation on unit, all help appricated.
- Patrick's Appliance Service asked 8 years ago
- last active 8 years ago
Is there a replacement model for this GE microwave that will fit in the same place, hookups? model CVM2072SMSS. Touch pad not working at all.
- Patrick's Appliance Service asked 6 years ago
- last active 6 years ago
- Guest asked 6 years ago
- last active 6 years ago
I need to replace the turntable motor. Could you please give me service manual or job aid for Whirlpool microwave/oven combo unit model number woc54ec0as00? Thank you.
- mdhomeservices asked 7 years ago
- last active 7 years ago
The turntable on my microwave will not spin.
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
The customer says that she does not get heat from the unit regardless if it’s in microwave or convention
But the unit dose have power
- Guest asked 8 years ago
- last active 8 years ago
Unit powers on without issue. I had set the timer on the touchpad (for testing purposes) by pressing 1 0 0 0 ( for ten minutes ) and then hit “start”. After I hit the START button on the touchpad, the timer was counting down without issue but the microwave was not on or activated. I could not hear the motor or the fan or magnetron or anything.
Could there be a bad switch on the board inside ?
- Guest asked 8 years ago
- last active 8 years ago
I have a GE spacemaker microwave the oven is not heating up to make tea we had a power spike the tea hardly heats up even after 6 seconds.
- Harley Clark asked 6 years ago
- last active 6 years ago
Hello,
I have a KitchenAid Wall Microwave/Oven combo. Recently the the turntable stopped spinning. I checked the coupler and determined that it is not broken and suspect the issue is with the turntable motor (the turntable now spins freely, I don’t remember it doing that before). I need to know how to access the underside of the microwave (at least I think I need to) in order to replace the turntable. I’ve looked online and can’t find any videos or instruction on how to do this. Can you please help me with this issue or provide direction to reference materials to complete this task?
Thank you,
Jeff Wessling
- Guest asked 7 years ago
- last active 7 years ago
How do I gain access to springs.
One door spring broke, should I replace both?
Access to replace springs. Video etc.
Do I have to watch out for fragile ribbon cable on top panel that can crack.
- Guest asked 7 years ago
- last active 7 years ago
This microwave will shut off mid cycle. The control will stay completely blank and nothing will happen. If you leave it unplugged for a little while it will cut back on and functional normal for a few cycles. Is the the control board going bad, or is it the mag tube interfering with the board and shutting it down. Are there any test I can do to check this, as everytime I am there after I plug unit up it will work fine for many back to back cycles
- Guest asked 8 years ago
- last active 8 years ago
