Brand: Electrolux

Ice build-up in freezer, Humming sound, Whining sound.

Not cooling, Leaking water, Frozen items in freezer melt.

Not cooling, Ice crystals.

Door is difficult to close, Door sticks, Door will not close.

No cool in fresh food section, Unit continually runs, Will not run.

Leaking water, Partial cubes, Ice clumps up

Low ice production, Water in tray but no ice, Frost in ice room.

Low ice production, Water in tray but no ice, Frost in ice room.

do you have a video or something on how to replace the icemaker?

says the freezer is freezing everything so it appears to b cold enough. We do not work on these that often really the diagnostic info and any bulletins is what i really need

Evap fan motor cycles on and off It started out cycling about every 2-3 seconds. After a couple of minutes it cycles to the point that it continues to turn, but not a full speed.
1. What causes this?
2. If it is the board, how do I test it to determine that it is the board?
3. If it is a bad motor (?) how do I test this?

I’ve never tested a fridge board or run it through a diagnostic test.

I just replaced the thermostat and found the evap fan motor cycling on and off about every 2-3 seconds. Is this a bad motor or board or ?
Why is it cycling? I have never come across a cycling motor before. It either worked or it didn’t. How can I check to determine IF it is a failing motor?
Thank you

washer not running will not enter diagnostics, beeps three times with new board, nothing else

Electrolux. No matter what setting it’s set to the washer always uses scorching hot water. Coworker replaced valves and main board still only using hot water though. I have a kenmore today with the same issue and just wanted to know what it could be causing it? Hoses installed correctly, settings are properly set..

Error code EY (or5Y) ES.
Was recommended to place the main power board (under the front let side) used part number 241996320
Replaced the board yesterday and it started up and was running fine now late this morning it stopped again with the same error code.
What would you recommend next. The unit is 3 years old.

error code 03

My customer broke the timer shaft on her dryer. She doesn’t want to replace the timer if I can somehow fix it. The knob and shaft separated from the timer.
I have fixed a customer’s water dispenser on his fridge door by installing a $4.00 door bell push button device. He didn’t care how it looked, he just wanted his water to work.
Is there a way that I can get her timer to work, without buying another $120.00 plus timer.

Hello, I have a dryer the is showing an e71 error code. all the sensors are checking out good the only thind is one of the 3 coils is bad would that cause an e71 code?

hi i saw the breakdown here but it doesn’t show screws or video. is this pretty straight forward?

UNIT HAS “SY CE” ERROR CODE AND WON’T DO ANYTHING. I HAVE NO PAPERWORK ON THIS UNIT. TX

THE EVAP COIL HAD A LEAK WHICH I REPAIRED. I RECHARGED THE SYSTEM. I HAVE 0 PSI AT THE PROCESS STUB AND ABOUT A 70 DEGREE DROP ACROSS THE CONDENSING COIL. THE UNIT ISN’T COOLING PROPERLY STILL. THE TEMP DROP ACROSS THE COIL HAS ME STUMPED AS SEEMS TO ME THAT IT SHOULD BE WORKING. ANY THOUGHTS? TX

Door handle loose how do I check or tighten hardware inside door