Brand: KitchenAid

Hi Folks,
This dryer was in a very poor condition. The pulley had fallen off the fan and the owner kept using it with no circulation of heat. No fuses were found to be defective. Element checks out! Proceeded to clean the unit thoroughly. Took care of the pulley and circulation problems. Put it all back together and no heat. Check the board and it was fried. Installed a new board and still no heat. There was no tech sheet with the unit! Now I have 240v going to the board (two legs of 120v each) but where do I find the legs coming out. It’s the heating cycle because the dryer is turning but no heat. I need a tech sheet and some expertise on getting this unit on board!
Thank you,

Jan
Barney’s Appliance

My Kitchenaid dishwasher will not start.

I am working on a kitchen aid refrigerator model that has no water and no ice.
Wiring diagram is missing. Dispenser panel switches work ok but no 120 volts to valve. Any help is appreciated

Hi,
This is a high end unit. Complaint was that temperature in the unit was low. Upon arrival it was apparent the condenser coils have not been cleaned in a while so we cleaned the coils. Seemed to cool properly. Got a call back that the temperature in the freezer was low. Customer saw some ice on the back wall of the freezer. He shut the unit off so it could defrost. He put it back on in the morning and we got there yesterday and all seemed well. Drawing 1.6 amps. Could someone tell me if there has any issues with this unit concerning the described problem? Any sensor or mother board issues?

Ice Ball building at the back of icemaker assembly at the ceiling and back wall inside FF section….

The dishes on the top rack of my Kitchenaid dishwasher are not getting clean.

is half of the dual broil element suppose to come on in bake mode?

Seems like the main oven door is not contacting with the latch/light switch.

The ice maker in my kitchen aid refrigerator is not working at all.

My KitchenAid dryer will not start, any recommendations of where to start ?

I’m having a tough time putting this ice maker in harvest to test operations, and also the ohm reading on the manufacturers literature doesn’t seem realistic for the ice maker motor, so I’m left scratching my head as to whether I really have a bad ice maker or if I’m not actually troubleshooting it right. Please help! I’m a 13 year experienced A/C tech, but appliances are fairly new to me. Thank you.

my French door kitchenaid refrigerator is leaking water.

Does everything but heat(no heat).
Would these give quartz heat and Mag heat/ one without the other? Would it heat at all if the Mag is down?
Thanks,

THIS IS A VERY LARGE KITCHENAID WITH THE COMPRESSOR ON TOP. THE COMPLAINT IS THAT THE FRIDGE AND FREEZER GET TO WARM. I CHECKED THE AIR DIFFUSOR AND IT WAS OPEN, AND NOTICED THAT THE UNIT WAS IN DEFROST MODE. I HAVE RESEARCHED DEFROST THERMOS AND TIMERS. COULD IT BE THAT THE UNIT IS GOING INTO DEFROST TOO OFTEN? THANKS, TODD FROM NY.

My kitchenaid washer is leaking and has a broken lid switch.

My kitchen aid oven will not turn on, also door will not open.

I CLEANED THE COILS TO THE BEST OF MY ABILITIES, BUT THEY WERE HARD TO GET TO. I MANUALY OPENED THE AIR DIFFUSER, AND CHECKED THE EVAP. THE EVAP HAD A CONCENTRATION OF ICE BUILD UP IN ONE AREA, BUT EVEN IN ALL OTHER AREAS. THE FANS ARE BOTH RUNNING FINE AS WELL AS THE COMPRESSOR. WHEN I LEFT I COULD ONLY GET THE FRIDGE TO 48 AND THE FREEZER TO 20, BUT THE UNIT WAS EMPTY AND ROOM TEMP WAS ABOUT 80. YOUR THOUGHTS? THANKS, TODD FROM NY.

I had posted on this dishwasher yesterday. I went back this AM to double check it.
This is a solid door unit (stainless) no vent assy on this door or in the front.
It does have 3 small vent slits on the top left side of the console, it looks like for a vent but no flap assy in the door. I had the unit out on the floor with the front off. The metal bracket in the console has cut out as for mounting of a vent assy. but nothing there. I’m not finding anything on a vent issue.
What am I missing on this one?

WHEN I GET IN FRONT OF THE UNIT I WILL CLEAN THE CONDENSER COILS, THEN I WOULD LIKE TO LOOK AT THE EVAPORTOR, BUT I DO NOT KNOW EXACTLY WHERE IT IS LOCATED. THREE QUESTIONS, AM I ON THE RIGHT TRACK WITH THE DIAGNOSIS, IS THERE MORE THAN ONE EVAPORATOR, AND IF YOU HAD TO GUESS, WHAT IS THE MOST COMMON NOT COOLING PROBLEM WITH THE KITCHENID FRIGES. THANKS. TODD FROM NY.

Customer says was making a very loud noise for a while the sound went away and it still worked for a few days then it quit washing and does not make any noise. Any clue what to look for ?

Diagnosed this as needing a capacitor but can’t find it in stock, do you guys carry it?

My name is Roland,
Question: I am working on a Kitchen Aid dual fuel gas range MD# KDRU7893VSS03 SN:DB1375935. The issue with this unit is there’s an error code which says NTC out of Range. I have tested all fuses in the back of this unit, I have changed the sensor -W1076760, the boiler assy -9758598, the appliance manager-w10339702. Still when power up, it goes into lock out with NTC out of range, call for service.
Can anyone help with this issue please. I await your response.
Roland

I have this double wall oven. The MW display says door. I have run into this before but those MW’s have two cartridge fuses, and one would blow. This MW only has one fuse and it is good. The door switches checked good, but I replaced them anyway, still didn’t work. Anyone have an answer or suggestion ?

KUDS30IXBL8 – Black
KUDS30IXWH8 – White
KUDS30IXBT8 – Biscuit
KUDS30IXSS8 – Stainless Steel

I have a KitchenAid dishwasher.
This unit when the customer uses a heated wash or dry condensates from the water inlet on the left side of tub. The insulation blanket on the unit has a 12″ circular mold spot and the cabinet has the same size water spot. The flap in the inlet is fine. It is pretty tight in the cabinet. The unit is about 11 months old the home is also new.
The customer saw the water mark on the cabinet under the sink.
Any advice on this one sure would be appreciated.

I checked all the main/working components, the line, etc. Then got to the disposal and realized the customer’s had installed a new one and forgot to punch out the drain tab for the dishwasher. Please be sure to check these simple things and save yourself a trip. I’m starting to ask this now when they call in with dishwashers not draining. Just a reminder for all you repair technicians that will read this forum.

Where can I find the part numbers for the water lines going from the water inlet valve to dispenser and icemaker ? Both are cracked at the 90 degree elbow at the valve. I have a picture of the end at the water valve but don’t know how to upload on here if its even possible.

I found the control bad but then when I reassembled the unit it began working. She wanted to keep using as is instead of replacing right away but I still need that part number if you have it handy. Thanks.

found leak in freezer evap. replaced evaporator in freezer will not go below 35 Degrees. .

Question on this range .The complaint is the temperature doesn’t rise above 180 degrees.
Technician came out he found in both bake and broil cycle part is on
the electric element just below the broiler burner . We are not familiar with this type of range. We will really appreciate any input.