Error code

Hello

        The F6 E0  error is A LOST COMMUNICATION. SUGGESTED CORRECTIVE ACTION See below. See complete diagnostic technician manual link below. Matt Ace technician 

A. Unplug range or disconnect power.
B. Open the console and make sure the P6 connector on the appliance manager
and the P2 connector on the user interface are fully inserted.
If not, plug in connectors and go to step F.
If fully plugged in, go to step C.
C. Visually inspect all of the four wires between P6 on the appliance manager and P2
on the user interface. Make sure the wires are not cut or pinched. If the wires
appear to be intact, perform a continuity check between Pin 4 of the appliance
manager and Pin 4 of the user interface. Do the same for Pins 1, 2, and 5. Both of
these checks should result in a reading of less than 5Ω.
If either of these checks fail, go to step E.
If these checks pass, reconnect P2, then go to step D.
D. Replace the appliance manager. Ensure all connectors are properly seated; then go
to step F.
E. Replace the wiring harness (signal) and go to step F.
F. Ensure all wiring connections are made.
G. Replace all parts and panels before operating.
H. Plug in range or reconnect power.
I. Observe for longer than one minute.
J. If the error does not appear, initiate a bake cycle. Let the cycle run at least one minute.