The unit runs fine till the end then it doesn’t drain and the two LEDs blink. If I unplug it eventually it will clear and repeat the same problem. Any Ideas?
Model Number
LFBD2409LB
What have you tried so far?
I have checked the connections and connectors. They are fine. Is it the board or touch pad. Are the two blinking LEDs an error code. They are not in the tech sheet. IS the service manual helpful on this problem?
Request Resource Materials
Service diagnostics guide, Service bulletins, Any available materials
- Pancakes asked 6 years ago
- last edited 6 years ago
Hello
1) All LED option flashing lights indicates a power failure has occurred. Press START/Cancel pad and reselect desired option cycle.
2) If Status LED is flashing – That is caused when the door is opened.
See complete diagnostic link below.
- AV Repair Help answered 6 years ago
- You must login to reply
Your Answer
Please login first to submit.
