- Debra Klein asked 9 years ago
- last active 9 years ago
My door wont latch shut on my Samsung microwave.
- Don Kopecky asked 9 years ago
- last active 9 years ago
ciruct barker is good but im not getting any power to the unit
- Guest asked 8 years ago
- last active 8 years ago
My Whirlpool microwave does not always heat.
- Fred Abernethy asked 7 years ago
- last active 7 years ago
door seems to be held on by 2 clips which are attached by some sort of rubber cement. is there a part # for this, or an after market product?
- Guest asked 6 years ago
- last active 6 years ago
I cannot get the controls to respond on my microwave.
- Patrick's Appliance Service asked 6 years ago
- last active 6 years ago
Kitchenaid built in oven microwave combo KEMS308SSS00. Original call was for a F1E5 error inverter. Inspection of inverter the board was clearly burned in several areas. Replaced inverter board and main control board.
When powered back on got F0E6 lost communication error. Checked all fuses and wires between Appliance Manager Board and microwave user interface. Had to replace manager board. After replacement, F1E5 error came back.
What have I overlooked or done incorrect? I would like to get this running for the family. Thank you.
- Guest asked 6 years ago
- last active 6 years ago
Microwave stops heating after 1.5 minutes. humming also stops but timer continues.
- Harley Clark asked 5 years ago
- last active 5 years ago
Already checked and tested power, fuses, magnetron, capacitor and wiring harness for damage.
- Guest asked 2 years ago
- last active 2 years ago
- shawn asked 9 years ago
- last active 9 years ago
My GE microwave is unresponsive and shows nothing on the display panel.
- Patrick's Appliance Service asked 9 years ago
- last active 9 years ago
My GE microwave has no power and is completely unresponsive.
- Curtis Appliance Repair asked 8 years ago
- last active 8 years ago
This microwave will shut off mid cycle. The control will stay completely blank and nothing will happen. If you leave it unplugged for a little while it will cut back on and functional normal for a few cycles. Is the the control board going bad, or is it the mag tube interfering with the board and shutting it down. Are there any test I can do to check this, as everytime I am there after I plug unit up it will work fine for many back to back cycles
- Guest asked 8 years ago
- last active 8 years ago
The controls on my microwave are not responding properly.
- Harley Clark asked 6 years ago
- last active 6 years ago
My GE microwave is not getting any power to it.
- Fred Abernethy asked 6 years ago
- last active 6 years ago
GE Profile microwave will not turn itself off. When the door is opened, the turntable starts to run and the oven is on Tried closing the door three time as suggested on a website — no luck
- Patrick's Appliance Service asked 6 years ago
- last active 6 years ago
- Guest asked 5 years ago
- last active 5 years ago
My microwave just stopped working in the middle of a heating cycle as I was opening the door. No power, no lights
- Harley Clark asked 5 years ago
- last active 5 years ago
FAN RUNS EVEN WHEN MICROWAVE IS OFF AND CODE 161. WHAT COULD IT BE ?
- Guest asked 5 years ago
- last active 5 years ago