Repair Help

Washer starts cycle then stops, Stator has an open winding.

Water drains while filling, Leaking water.

Water leaking onto the floor, Washer hums.

No power to PCB main.

Not enough water to agitate, Washer overflows.

Housing is leaking, Moldy Smell, Product not flushing through the machine.

Water will not pass through valve, Will not stop filling.

Water puddling under the washer, Low water pressure into tub.

Water leaking between the tub, Clothing gets caught between tubs.

Water spraying at incorrect angles, Nozzle is cracked or damaged.

Drum is off balance or tilted, Drum knocks into cabinet, Will not spin out, Banging noises.

Lid will not unlock after draining, Starts when you slam the lid closed, Will not start.

Will not enter diagnostic mode.

Buttons are not springy, Cannot start machine, Error Codes on display

Will not run, Buttons do not function, Lights will not display, hums but will not start.

Lid slams shut, Will not close, Lid closes unevenly

Lid slams shut, Will not close, Lid closes unevenly.

Lid plastic is cracked or broken, Does not close correctly.

Scraping sound during operation, longer than normal dry times.

Scraping sound during operation, longer than normal dry times.

Rattling Sound, Grinding noise, Screeching Sound, Screeches, Squeaky Drum, High Pitched Sound, Noisy, Belt Slipping.

Drum rotates slower than usual, Drum will not spin.

Unusual noise or an electrical humming sound.

The dryer will not heat.

Dryer is overheating

Clothes are still wet, takes too long to dry.

How do i replace the belt on this unit.

I replaced the water valve , worked 2 days. I checked the line from rear of cabinet to the fill spout of the ice maker, it was frozen again. sears sent customer a new water valve, I installed it (it comes with new water lines attached to valve) it worked 5 days. note water line is filtered. they sent her another valve I installed it. the seals around the new valves I notice have been beef up to seal better. WHATS GOING ON?

I need to know how force defrost and / or put in diagnostic mode, error codes

This is the fresh food ice maker not the freezer . Does the service diagnostic test #99 energize both valves?