Repair Help

My ge range is not keeping the proper temperature that it is set to.

The control panel on my range is unresponsive.

My range is giving off a gas smell that is concerning to me.

The front left burner is out on my range.

I cannot seem to get the door to close on my GE range.

The fan in my oven sounds like its grinding up against something.

The front right burner is out on my range.

I do not think my range is level.

The control panel on my range is not working like it should.

The door on my range will not close.

The door will not stay shut on my range.

The door is not sealing shut properly on my GE range.

I need to wiring diagram for this unit, I am having an issue with the power supply to the water valve. Every time the ice maker goes into a fill the water comes out of the dispenser. When you press the water dispenser the water comes out as well.

My GE oven will not turn on or do anything.

The front left burner is out on my cooktop.

My stove is not level and i cannot figure out how to adjust the legs.

I am starting to get concerned because my GE range smells like gas.

The door will not seal shut on my GE range.

The controls on my GE range are not working.

The fan sounds like its rubbing up against something.

My range will not stay at the set temperature.

The door on my range is broken.

The controls on my GE range are not working at all.

My GE range is not cooking food properly.

My GE range will not keep the proper temperature.

The front right burner on my range will not work.

I cannot get the door to close on my GE range.

Customer icemaker not producing ice. No water in Mold. No 120vac to icemaker at test points. Tried jumping. No movement. Tested harness checks for continuity. Replaced icemaker anyway just to check my diagnostics. No power to new icemaker. This unit uses. Adaptive defrost and control boards..
What do I test next? What part supplies power to icemaker and where is it located? I believe boards are located in fresh food section. Your help is appreciated.
G
Newtech2012

When I run the diagnostic it comes up with an error for fresh food “Thermister error 02 3x”
“Z3 evaporator thermistor “
But on the diagnostic diagram it says to check reading on zone 3 thermister and condenser thermister leads which I couldn’t get to.

New part number is a bit different than original one. missing 2 terminals. does anyone know if there are any modifications or a correct sub part number. no instructions in box