Repair Help

Distorted flame.

No power to the PCB main.

Error codes 81 82 83 84.

Dull light from bad LEDs.

Dull light from bad LEDs.

Non responsive, microphone fails, Faulty image on display.

Popping or cracking noise when opening or closing the door, Sweating on the door mullion, door not closing properly.

Power interruption to ice route.

Water leaking on floor, the heater will fail.

Dull light from bad LEDs.

Not producing ice, Hollow ice cubes.

No defrost, No air flow across evaporator, higher temperature reading.

No air flow across evaporator, higher temperature reading.

Air flow issues, not proper temperature readings, Motor noise.

Top and sides of the fridge would be warm, no air flow from under the fridge.

Buzzing or clicking noise.

Display temperature reading is not correct, Not enough cooling, too much cooling.

Top of fridge is warm while the bottom is cold.

Hollow broken ice cubes, over production of ice.

Higher temperatures in the ice room, Auger is not turning in the bucket.

Moisture leaking from the auger bucket, Higher temperature in the ice room causing the ice to be wet.

Air leakage, physical damage, warm in the fridge, humidity in the fridge.

One door will open when closing the other door, cracking or snapping noise, rough to open or close.

Ice stays in chute, Massive frost build up around auger bucket and ice cap, Leaking water from ice melting.

Cannot switch between cubed and crushed ice.

My Samsung refrigerator is not working properly.

about every 2 months frost builds up around fresh food fan motor and coil. do you have any idea on what to check for.

it runs but no heat i called lg tech line and they told me it could related to the vent. They also told it could be the main board.

The washer will still overflow after replacing the pressure switch and hose. We double check to ensure that the hose is cleared as well. It will also only overflow on the rinse cycle. During the fill cycle it will fill to the proper level and then once it is stopped and turned to the rinse cycle it will not drain out first. We have also tried replacing the timer as well with the same issue.