Appliance Type: Dishwasher

I’ve got an error code E08,03 – short circuit coil, wiring to coil or controller, replace controller

The water seems to be entering the tub okay when I put it into diagnostics, however when I tried to put it into a short cycle diagnostics mode, the dishwasher wouldn’t enter into this diagnostics mode. I’m suspecting a bad control board.

After beginning a cycle, the initial fill seems to take longer than normal. After a few moments, the unit begins to drain (without beginning to wash) and the “Smart Auto” light blinks.
I have cycled power to reset.
I have also already replaced the thermistor.
There is no water in the drip tray beneath the unit.

The original complaint was that this Dishwasher was not responding to anything. NO POWER whatsoever. So we replaced the main control board and now the dishwasher will turn on but it the display keeps Flashing and not responding to anything. We have reset this board multiple times but it doesn’t seem to help. Does this unit need to have the control board be programmed or could this board be faulty?

the programming starts normally, water and washing works, when it is on the programming to drain the water the pump does not turn off and shows error I30, I have already replaced the board and the same defect continues

I Keep getting smart auto and heavy lights blinking after the dishwasher is running maybe five minutes, It seems like when it starts it automatically drains. I’ve reset the dishwasher multiple times each time it allows the psycho to go a little bit further but it doesn’t look like it’s putting much water in the dishwasher.

This washer is brand new i have looked at the info it came with is says if 888 flashed its the flow meter or the harness and i have replaced the flow meter still the same result

Most is the control panel works fine except for the Normal Wash and Heavy Wash options on the right side.

Those two options will not light up at all.
No matter what other options or settings I press I can’t get those two buttons to change, work or even turn on at all.

Code E9 is showing, how can i reset the appliance?

My Kitchen aid dishwasher fills with water then stops.

My Kitchen aid dishwasher is leaking water from the bottom center.

My dish washer is not drying the dishes at all.

My dishwasher will not drain. Also there is a burning smell coming from it.

My dishwasher seems like its not getting power to it.

My dishwasher will not fill with water.

The dishes in my dishwasher are coming out dripping wet.

The detergent dispenser will not open.

I can not get the door open on my KitchenAid dishwasher.

My KitchenAid will not start or do anything at all.

My KitchenAid dishwasher has water in it. Will not finish cycle.

My Kitchen aid dishwasher is not cleaning properly.