Appliance Type: Stove / Oven / Cooktop

My technician changed two infinite switches on a radiant cooktop.

The part that was changed is 700855K. Issue is that the two right side burners, after connection, control each other’s heat level. Burners turn on independently and the issue with heat control is only applicable if both burners are operating simultaneously.

Could you provide guidance on proper wiring instructions for these switches? My thought is that the technician did the wiring incorrectly. The old switch for reference is part# 203147. The confusion lies in a difference for terminal markings between the old switch (203147) and new switch (700855K).

I’m the owner, but not a technician. Please let me know if there is a bulletin or supporting document for the issue.

Thank you,
Greg Bahry
832-656-9034

I have installed three sets of door hinges. I know these hinges don;’t work because I have run into a few of these stoves.
Has anyone heard of a solution to this? Whirlpool has to know about it because I had my parts supplier inquire a year ago. I had one customer that was ok with a latch on the side of his stove. Any suggestions ?
Thanks,

I don’t have a model number on this oven. I was working in this kitchen removed the oven door improperly and could not reinstall it. I pushed the hinges and set the catches and attempted to put the door back on. After a little effort I got it back on but then could not open it. The door is locked. I have tried a coat hanger to pull on the lock without success. I have tried setting self clean and then cancelling it and turning off the circuit breaker for a few minutes. I would be very greatful for any tips on how to get the door open. Thanks

—

you replied to me yesterday that you had no video for this model of gas range is there a manual or written instructions that I can look at, thank you

I have a GE stove, need to change door springs how do you remove the tracks from bottom draw to gain access to little door to change spring any help would be appreciated thank you

oven turns off

My GE oven is displaying an F7 error and is powering off by itself.

My GE oven is not getting any heat.

My GE oven is not heating and there is a burnt spot on the bottom element.

I hear clicking but not lighting

My GE oven is not baking things.

the customer is saying that the oven will go on by itself from time to time

I have replaced heating element and the board but still no heat. Please help

oven wont work I reset house breaker it works when I try again I get error code feature not aavailable theni need to reset breaker and repeat steps

unit flashes f 2

Need information on this dual fuel wolf stove. How to replace the thermistors in the oven? If you have a break down or know how to get into the oven and change the oven sensors?

The food in my Kitchenaid oven does not cook properly. Any suggestions?