Brand: Electrolux

No matter where the control is set it freezes every thing.
How do I test this unit?
I need a service manual and tech sheet and any advice you can give

Finding plastic pieces in tub when cycle is finished. Took agitator out, looks ok, no pieces come from it. Seems as if inner tub has a little play in it. This may be causing the excessive shaking. I don’t see any pieces broke off of top cover. I would say that’s where the pieces are coming from. The washer is only 3yrs old. have there been issues with loose parts or suspension troubles, or balance problems???? Put the washer in spin with no clothes in it, and it was shaking too much, and did bang slightly.

This is is a Frigidaire oven this the door lock error? Which board controls it if it is,? How can I check this issue?
I need a service manual and tech sheet and your expert advice.

The door glass on my washer is damaged

My Electrolux washer is displaying a 69 error code.

My Electrolux washer is not spinning.

The water will not drain out of the washer.

My washer is displaying an 84 error code.

My Electrolux washer is off balance and shakes around when in use.

My Electrolux washer is displaying a 42 error code and im not sure what it means.

My washer is completely unresponsive.

I am having issues with the panel on my Electrolux washer.

My washer is displaying error code 35 and I’m not sure what it means.

The soap dispenser is not working on my Electrolux washer.

My Electrolux washer will not fill with water.

My washer will not power on or do anything at all.

My washer is making a grinding noise.

The door strike is ok. The Reed switch is okay. There is no continuity at J2 . The harness wires are good.
Do I need to check the wax motor.
I changed the door switch with a new one. Still the same. Lock error.
Is it the electronic control?
How could there be continuity at J2 with the door shut?

I need any info on this microwave you can give me. The customer states you hit the button, it beeps once and shuts down.

FRESH FOOD SECTION NO ICE PRODUCTION
FREEZER SECTION LOW ICE PRODUCTION CHECK WATER VALVE ELECTRICALL OK BUT THE WATER COMING IN TO THE WATER VALVE BELOW 30 PSI WILL THAT CAUSE THE ICE MAKERS TO NOT PRODUCE ICE OR LOW ICE PRODUCTION OF ICE I DON’T BELIEVE THE ICE MAKER CAN BOTH BE BAD ANY SUGGESTIONS ON WHAT TO CHECK

I’m trying to replace the main power board. replaced old board but the fridge dose not start up, no lights nothing, controls dead. I also replace the thermistor
Reinstalled old board fridge started up, lights working, controls working.
Installed another new board. nothing.
Fridge is also missing the tech sheet.
Initial problem, Items freezing items in fresh food section,
Thanks for your help

I’m not getting any power to my defrost t-stat. I know it’s the main board, but on this style with the user interface board on the side of the door, do I have to change the user interface board as well?

My dryer powers on/off via power button just fine. The knob selector also works appropriately. The start button does not always register being touched. Likewise, other “buttons” do not sense being touched (Temp, dry level, dry time, options, set, cancel). When the dryer does start, there is a lot of rapid beeping during the drying cycle. I cannot enter into diagnostic mode or perform a factory reset due to the lack of response to the key pad. I attempted to replace the UI board (part # 5304505611) but that did not resolve the problem. Last night, after managing to get the dryer started and run through a complete drying cycle, the unit restarted on a cycle without the unit being touched.

I need a tech sheet and if this sounds familiar please advise.